怎样把metro-trk 写到 mxl ads板.txt

应用在moto龙珠芯片的开发手册

步骤:

1) Move all S22 dip switch positions to the ON position
2) Move dip switch S1-1 to the ON position with S1-3 in the OFF position
3) Connect an RS-232 serial cable from the host computer to the UART1 connector
4) Apply 3v to the board
5) Open a Windows command window
6) 进入mx1flash.exe 和ARM_MetroTRK_Flash_U1_57600_I_Ext_SDRAM.txt 所在的目录下,Use the mx1flash.exe utility to download the MetroTRK:
	mx1flash <comport#> 8800000 C000000 <TRK file>
  
    e.g.:  mx1flash 1 8800000 C000000 ARM_MetroTRK_Flash_U1_57600_I_Ext_SDRAM.txt 

7) You should see messages similar to the following:

MX1 SyncFlash Programming Utility

Connecting to ADS board...
Loading flashing code...
Loading image...
File size is:  27064 bytes
Loading ARM_MetroTRK_Flash_U1_57600_I_Ext_SDRAM.txt
to address 0x08800000.
Bytes Xfered:  27064
Transfer complete!
Flashing in progress....
Erase All completed.
Erase OK.
Flash operation completed.
Validating Data.....
Flash Successfully Completed.

8) If not, then remove power from the board and restart with step 4
9) Remove power from the board
10) Set S22 dip switch position 2 to the OFF position
11) Connect the serial cable to the port MetroTRK is using
12) Open a terminal emulation program and set the appropriate port to:

	- <BaudRate> - the baud rate the chosen MetroTRK is using
	- 8 Data Bits
	- No Parity
	- 1 Stop Bit
	- Xon/Xoff Flow Control
13) Re-apply power to the board
14) If you do not see the MetroTRK Welcome banner, remove power and start from 
    step 4 again
15) 关闭 the terminal emulation program


搞定!