flash_a.crp

PSD4256G flash inside cpld example code

 ***************************************************************************
                        PSDsoft Express Version 7.80
                    Output of PSD Configurations
 ***************************************************************************
  PROJECT    : flash_a                        DATE : 04/08/2003
  DEVICE     : PSD4256G6V                     TIME : 15:00:31
 ***************************************************************************


 ==== Bus Interface ==== 

 Data Bus Width                                                    = 16-Bit 
 Address/Data Mode                                                 = Non-Multiplexed 
 ALE/AS Signal                                                     = OFF 
 Control Signals                                                   = /WR,/RD,/BHE 


 ==== Other Configurations ====  

 Enable Chip-Select Input(/CSI)      = OFF 
 Enable Standby Voltage Input (PE6)  = OFF 
 Enable Standby-on Indicator (PE7)   = OFF 
 Enable RDY/Busy function (PE4)      = OFF 
 Security Protection                 = OFF 


 ==== JTAG Configurations ====  

 Enable TMS/TCK/TDI/TDO on PE0/PE1/PE2/PE3, respectively = ON 
 Enables JTAG signal TSTAT on PE4 = ON 
 Enables JTAG signal TERR on PE5 = ON 
 User Code = FFFFFFFF

 ==== Flash Sector Protect ====  

 Flash Sector 0 is unprotected 
 Flash Sector 1 is unprotected 
 Flash Sector 2 is unprotected 
 Flash Sector 3 is unprotected 
 Flash Sector 4 is unprotected 
 Flash Sector 5 is unprotected 
 Flash Sector 6 is unprotected 
 Flash Sector 7 is unprotected 
 Flash Sector 8 is unprotected 
 Flash Sector 9 is unprotected 
 Flash Sector 10 is unprotected 
 Flash Sector 11 is unprotected 
 Flash Sector 12 is unprotected 
 Flash Sector 13 is unprotected 
 Flash Sector 14 is unprotected 
 Flash Sector 15 is unprotected 
 Flash Boot Sector 0 is unprotected 
 Flash Boot Sector 1 is unprotected 
 Flash Boot Sector 2 is unprotected 
 Flash Boot Sector 3 is unprotected