landzo

【开源】线性CCD自适应性算法攻略

/**********************************************************************************
********************* (C) COPYRIGHT 2012 蓝宙电子科技有限公司 *********************
***********************************************************************************
 * 描述         ：线性CCD测试程序
 *
 * 实验平台     ：蓝宙电子XS128系统板 + TSL1401线性CCD传感器
 *
 * 作者         ：蓝宙电子科技有限公司
 * 淘宝店       ：http://landzo.taobao.com
 * 网站         ：http://www.landzo.cn
**********************************************************************************/
/*
*********************************************************************************************************
*
*                                      MCU: MC9S12XS128MAL - 112Pin
*                                      OSC: 16.000MHz
*                                      BUS: 40.0MHz
*
* File : SCI.h
* By   : Ke Chao
*********************************************************************************************************
*/

#ifndef   SCI_H
#define   SCI_H


#define ERR_OK           0U            /* OK */
#define ERR_SPEED        1U            /* This device does not work in the active speed mode. */
#define ERR_RANGE        2U            /* Parameter out of range. */
#define ERR_VALUE        3U            /* Parameter of incorrect value. */
#define ERR_OVERFLOW     4U            /* Timer overflow. */
#define ERR_MATH         5U            /* Overflow during evaluation. */
#define ERR_ENABLED      6U            /* Device is enabled. */
#define ERR_DISABLED     7U            /* Device is disabled. */
#define ERR_BUSY         8U            /* Device is busy. */
#define ERR_NOTAVAIL     9U            /* Requested value or method not available. */
#define ERR_RXEMPTY      10U           /* No data in receiver. */
#define ERR_TXFULL       11U           /* Transmitter is full. */
#define ERR_BUSOFF       12U           /* Bus not available. */
#define ERR_OVERRUN      13U           /* Overrun error is detected. */
#define ERR_FRAMING      14U           /* Framing error is detected. */
#define ERR_PARITY       15U           /* Parity error is detected. */
#define ERR_NOISE        16U           /* Noise error is detected. */
#define ERR_IDLE         17U           /* Idle error is detected. */
#define ERR_FAULT        18U           /* Fault error is detected. */
#define ERR_BREAK        19U           /* Break char is received during communication. */
#define ERR_CRC          20U           /* CRC error is detected. */
#define ERR_ARBITR       21U           /* A node losts arbitration. This error occurs if two nodes start transmission at the same time. */
#define ERR_PROTECT      22U           /* Protection error is detected. */
#define ERR_UNDERFLOW    23U           /* Underflow error is detected. */
#define ERR_UNDERRUN     24U           /* Underrun error is detected. */
#define ERR_COMMON       25U           /* Common error of a device. */
#define ERR_LINSYNC      26U           /* LIN synchronization error is detected. */
#define ERR_FAILED       27U           /* Requested functionality or process failed. */
#define ERR_QFULL        28U           /* Queue is full. */


/*
*********************************************************************************************************
* Description: No
*********************************************************************************************************
*/
void SCI0_Init(void);

uint8_t SCI0_SendChar(uint8_t Chr);

void SCI0_SendChar1(uint8_t Chr);

uint8_t SCI0_RecvChar(uint8_t *Chr);

uint8_t SCI0_RecvChar1(void);


#endif