msp430x42x0_lpm3.s43

MSP430F42x0.zip c语言 例程打包

;******************************************************************************
;   MSP430x42x0 Demo - FLL+, LPM3 Using Basic Timer ISR, 32kHz ACLK
;
;   Description: System runs normally in LPM3 with basic timer clocked by
;   32kHz ACLK. At a 2 second interval the basic timer ISR wakes the
;   system and flashes the LED on P1.0 inside of the Mainloop.
;   ACLK = LFXT1 = 32768Hz, MCLK = SMCLK = default DCO = 32 x ACLK = 1048576Hz
;   //* An external watch crystal between XIN & XOUT is required for ACLK *//	
;
;                MSP430F4270
;             -----------------
;         /|\|              XIN|-
;          | |                 | 32kHz
;          --|RST          XOUT|-
;            |                 |
;            |             P1.0|-->LED
;
;  L. Westlund / S. Karthikeyan
;  Texas Instruments Inc.
;  June 2005
;  Built with IAR Embedded Workbench Version: 3.30A
;******************************************************************************
#include  <msp430x42x0.h>
;------------------------------------------------------------------------------
            ORG     08000h                  ; Program Start
;------------------------------------------------------------------------------
RESET       mov.w   #300h,SP                ; Initialize stackpointer
Init_Sys    mov.w   #WDTPW+WDTHOLD,&WDTCTL  ; Stop WDT
SetupFLL    bis.b   #XCAP14PF,&FLL_CTL0     ; Configure load caps
SetupBT     mov.b   #BTDIV+BTIP2+BTIP1+BTIP0,&BTCTL   ; ACLK/(256*256)
            bis.b   #BTIE,&IE2              ; Enable Basic Timer interrupt
SetupPx     mov.b   #0FFh,&P6DIR            ; P6.x output
            clr.b   &P6OUT                  ;
            mov.b   #0FFh,&P5DIR            ; P5.x output
            clr.b   &P5OUT                  ;
            mov.b   #0FFh,&P2DIR            ; P2.x output
            clr.b   &P2OUT                  ;
            mov.b   #0FFh,&P1DIR            ; P1.x output
            clr.b   &P1OUT                  ;
                                            ;				          							
Mainloop    bis.w   #LPM3+GIE,SR            ; Enter LPM3, enable interrupts
            bis.b   #001h,&P1OUT            ; Set P1.0
            push    #2000                   ; Place value on stack
Pulse       dec.w   0(SP)                   ; Decrement value on stack
            jnz     Pulse                   ; Delay done?
            incd.w  SP                      ; Clean-up stack
            bic.b   #001h,&P1OUT            ; Reset P1.0
            jmp     Mainloop                ;
                                            ;
;------------------------------------------------------------------------------
BT_ISR;     Exit LPM3 on reti
;------------------------------------------------------------------------------
            bic.w   #LPM3,0(SP)             ;
            reti                            ;		
                                            ;
;-----------------------------------------------------------------------------
;           Interrupt Vectors
;-----------------------------------------------------------------------------
            ORG     0FFFEh                  ; RESET Vector
            DW      RESET                   ;
            ORG     0FFE0h                  ; Basic Timer Vector
            DW      BT_ISR                  ;
            END