hardware_settings.h

一个非常好的电源设计程序

/*
 * Hardware settings for the digital dc power supply
 * http://www.tuxgraphics.org/electronics/
 *
 * In this file you can:
 * - calibrate the ampere and voltmeter
 * - choose your hardware type: 22V 3A or 30V 2.5A
 */
#ifndef CAL_HW_H
#define CAL_HW_H


/* ================= uncomment this section for the model 22V 2.5A */

#define U_MAX 220
#define I_MAX 250

// internal adc ref voltage (should be 2.56V, can vary from uC to uC)
#define ADC_REF 2.60

// the divider R7/R8 [(R8+R7)/R8], you can calibrate here the voltmeter:
#define U_DIVIDER 11.25

// the shunt for current measurement (R4||R14|R34), you can calibrate here the 
// amperemeter.
// If you use 3*1.5Ohm 2W then uncomment this:
//#define I_RESISTOR 0.50
// If you use 3*3.3Ohm 1W then uncomment this:
#define I_RESISTOR 0.55

/* ================= uncomment this section for the model 30V 2.5A */

/* remove this line to uncomment

#define U_MAX 300
#define I_MAX 250

// internal adc ref voltage (should be 2.56V, can vary from uC to uC)
#define ADC_REF 2.60

// the divider R7/R8 [(R8+R7)/R8], you can calibrate here the voltmeter:
#define U_DIVIDER 13.19

// the shunt for current measurement (R4||R14|R34), you can calibrate here the 
// amperemeter.
// If you use 3*1.5Ohm 2W then uncomment this:
//#define I_RESISTOR 0.50
// If you use 3*3.3Ohm 1W then uncomment this:
#define I_RESISTOR 0.55

 remove this line to uncomment */


#endif //CAL_HW_H