logfile.log

AT91SAM9260 KERNEL2.6.19/BUSYBOX 1.1.3

-I- Waiting ...
connection : \usb\ARM0
board : AT91SAM9260-EK
target(handle) : 16800272
read chip ID : 0x019803A1 at addr: 0xFFFFF240
-I- Found processor : AT91SAM9260 (0x019803A0)
script file : AT91SAM9260_demo_linux_DataFlash.tcl
u-boot file: u-boot-env-df.bin
diskSize: 0x00400000
-I- === Performs sanity checks===
-I- === Initialize the DataFlash access ===
-I- Init SPI0 for DataFlash interfaces
-I- Configure SPI0 PIOs
-I- Reset the SPI0
-I- Configure SPI0 in Master Mode (no CS selected)
-I- Configure SPI0 CS0 for DataFlash AT45
-I- Configure SPI0 CS1 for DataFlash AT45
-I- Disable the RX and TX PDC transfer requests
-I- Reset all Counter register Next buffer first
-I- Enable the RX and TX PDC transfer requests
-I- End of Init_DataFlash
-I- Switch to the correct PCS of SPI0 Mode Register (Fixed Peripheral Selected)
-I- Chip Select 1 Selected
-I- Enable the SPI0
-I- Wait for dataflash ready (bit7 of the status register)
-I- DataFlash AT45DB321
-I- End of Select DataFlash
-I- Initialize SDRAM
-I- Configure PIOC as peripheral (D16/D31)
-I- Init MATRIX to support EBI0 CS1 for SDRAM
-I- Init SDRAM
-I- 1. A minimum pause of 200us is provided to precede any signal toggle
-I- 2. A Precharge All command is issued to the SDRAM
-I- *pSDRAM = 0;
-I- 3. Eight Auto-refresh are provided
-I- *pSDRAM = 0;
-I- *pSDRAM = 0;
-I- *pSDRAM = 0;
-I- *pSDRAM = 0;
-I- *pSDRAM = 0;
-I- *pSDRAM = 0;
-I- *pSDRAM = 0;
-I- *pSDRAM = 0;
-I- 4. A mode register cycle is issued to program the SDRAM parameters
-I- *(pSDRAM+0x20) = 0;
-I- 5. Write refresh rate into SDRAMC refresh timer COUNT register
-I- 6. A Normal Mode Command is provided, 3 clocks after tMRD is set
-I- *pSDRAM = 0;
-I- End of Init_SDRAM
-I- === Erase all the DataFlash blocs and test the erasing ===
-I- === Load the bootstrap: dataflash_at91sam9260ek in the first sector ===
-I- File size = 3946 byte(s)
-I- Boot File Written Successfully
-I- === Load the u-boot in the next sectors ===
-I- Send File ./u-boot-env-df.bin at address 0x00008000
-I- File size = 154020 byte(s)
-I- === Load the u-boot environment variables ===
-I- Send File tmp.bin at address 0x00004000
-I- File size = 16384 byte(s)
-I- === Load the Kernel image ===
-I- Send File linux-2.6.18-rc4-sam9260.img at address 0x00030000
-I- File size = 2211792 byte(s)
-I- === Load the linux file system ===