parameter.h

这是ti公司的一个重要的技术文档源码！ 三相异步电机无速度传感器直接磁场定向控制！ 主要是用于F2812

/* ==============================================================================
System Name:  ACI34

File Name:	PARAMETER.H

Description:	Parameters file for the Real Implementation of Sensorless Direct 
          		Field Orientation Control for a Three Phase AC Induction Motor. 

Originator:		Digital control systems Group - Texas Instruments

=====================================================================================
 History:
-------------------------------------------------------------------------------------
 05-15-2002	Release	Rev 1.0
=================================================================================  */

#ifndef PARAMETER_H
#define PARAMETER_H

/*-------------------------------------------------------------------------------
Next, definitions used in main file.
-------------------------------------------------------------------------------*/
#define PI 3.14159265358979

/* Define the system frequency (MHz) */
#define SYSTEM_FREQUENCY 150

/* Define the ISR frequency (kHz) */
#define ISR_FREQUENCY 20

/* This machine parameters are based on 1-hp WEG induction motor */
/* Define the Induction motor parameters */
#define RS 		1.723               	/* Stator resistance (ohm) */
#define RR   	2.011               	/* Rotor resistance (ohm) */
#define LS   	0.166619     			/* Stator inductance (H) */
#define LR   	0.168964				/* Rotor inductance (H) */	
#define LM   	0.159232				/* Rotor inductance (H) */
#define P    	4						/* Number of poles */	

/* Define the base quantites */
#define BASE_VOLTAGE    184.752       /* Base peak phase voltage (volt) */
#define BASE_CURRENT    5             /* Base peak phase current (amp) */
#define BASE_TORQUE     7.35105194    /* Base torque (N.m) */
#define BASE_FLUX       0.79616       /* Base flux linkage (volt.sec/rad) */
#define BASE_FREQ      	60            /* Base electrical frequency (Hz) */

#endif  // end of PARAMETER.H definition

//===========================================================================
// No more.
//===========================================================================