arp.h

这是基于TI公司的DSP TMS320DM642而开发的TCP/UDP协议

#ifndef __ARP_H
#define __ARP_H

#include "eth.h"
#include "csl.h"

/* ARP protocol HARDWARE identifiers. */
#define ARPHRD_NETROM	0		/* from KA9Q: NET/ROM pseudo	*/
#define ARPHRD_ETHER 	1		/* Ethernet 10Mbps		*/
#define	ARPHRD_EETHER	2		/* Experimental Ethernet	*/
#define	ARPHRD_AX25	3		    /* AX.25 Level 2		*/
#define	ARPHRD_PRONET	4		/* PROnet token ring		*/
#define	ARPHRD_CHAOS	5		/* Chaosnet			*/
#define	ARPHRD_IEEE802	6		/* IEEE 802.2 Ethernet/TR/TB	*/
#define	ARPHRD_ARCNET	7		/* ARCnet			*/
#define	ARPHRD_APPLETLK	8		/* APPLEtalk			*/
#define ARPHRD_DLCI	15		    /* Frame Relay DLCI		*/
#define ARPHRD_ATM	19		    /* ATM 				*/
#define ARPHRD_METRICOM	23		/* Metricom STRIP (new IANA id)	*/
#define	ARPHRD_IEEE1394	24		/* IEEE 1394 IPv4 - RFC 2734	*/
#define ARPHRD_EUI64	27		/* EUI-64                       */

/* Dummy types for non ARP hardware */
#define ARPHRD_SLIP	256
#define ARPHRD_CSLIP	257
#define ARPHRD_SLIP6	258
#define ARPHRD_CSLIP6	259
#define ARPHRD_RSRVD	260		/* Notional KISS type 		*/
#define ARPHRD_ADAPT	264
#define ARPHRD_ROSE	270
#define ARPHRD_X25	271		/* CCITT X.25			*/
#define ARPHRD_HWX25	272		/* Boards with X.25 in firmware	*/
#define ARPHRD_PPP	512
#define ARPHRD_CISCO	513		/* Cisco HDLC	 		*/
#define ARPHRD_HDLC	ARPHRD_CISCO
#define ARPHRD_LAPB	516		/* LAPB				*/
#define ARPHRD_DDCMP    517		/* Digital's DDCMP protocol     */
#define ARPHRD_RAWHDLC	518		/* Raw HDLC			*/

#define ARPHRD_TUNNEL	768		/* IPIP tunnel			*/
#define ARPHRD_TUNNEL6	769		/* IPIP6 tunnel			*/
#define ARPHRD_FRAD	770             /* Frame Relay Access Device    */
#define ARPHRD_SKIP	771		/* SKIP vif			*/
#define ARPHRD_LOOPBACK	772		/* Loopback device		*/
#define ARPHRD_LOCALTLK 773		/* Localtalk device		*/
#define ARPHRD_FDDI	774		/* Fiber Distributed Data Interface */
#define ARPHRD_BIF      775             /* AP1000 BIF                   */
#define ARPHRD_SIT	776		/* sit0 device - IPv6-in-IPv4	*/
#define ARPHRD_IPDDP	777		/* IP over DDP tunneller	*/
#define ARPHRD_IPGRE	778		/* GRE over IP			*/
#define ARPHRD_PIMREG	779		/* PIMSM register interface	*/
#define ARPHRD_HIPPI	780		/* High Performance Parallel Interface */
#define ARPHRD_ASH	781		/* Nexus 64Mbps Ash		*/
#define ARPHRD_ECONET	782		/* Acorn Econet			*/
#define ARPHRD_IRDA 	783		/* Linux-IrDA			*/
/* ARP works differently on different FC media .. so  */
#define ARPHRD_FCPP	784		/* Point to point fibrechannel	*/
#define ARPHRD_FCAL	785		/* Fibrechannel arbitrated loop */
#define ARPHRD_FCPL	786		/* Fibrechannel public loop	*/
#define ARPHRD_FCFABRIC	787		/* Fibrechannel fabric		*/
	/* 787->799 reserved for fibrechannel media types */
#define ARPHRD_IEEE802_TR 800		/* Magic type ident for TR	*/
#define ARPHRD_IEEE80211 801		/* IEEE 802.11			*/

#define ARPHRD_VOID	  0xFFFF	/* Void type, nothing is known */

/* ARP protocol opcodes. */
#define	ARPOP_REQUEST	1		/* ARP request			*/
#define	ARPOP_REPLY	2		/* ARP reply			*/
#define	ARPOP_RREQUEST	3		/* RARP request			*/
#define	ARPOP_RREPLY	4		/* RARP reply			*/
#define	ARPOP_InREQUEST	8		/* InARP request		*/
#define	ARPOP_InREPLY	9		/* InARP reply			*/
#define	ARPOP_NAK	10		/* (ATM)ARP NAK			*/

/*
 *	This structure defines an ethernet arp header.
 */

 struct arphdr
{
	Uint8    ar_hrd[2];		/* format of hardware address	*/
	Uint8    ar_pro[2];		/* format of protocol address	*/
	Uint8    ar_hln;		/* length of hardware address	*/
	Uint8    ar_pln;		/* length of protocol address	*/
	Uint8    ar_op[2];		/* ARP opcode (command)		*/

	 /*
	  *	 Ethernet looks like this : This bit is variable sized however...
	  */
	Uint8     ar_sha[ETH_ALEN];	/* sender hardware address	*/
	Uint8	  ar_sip[4];			/* sender IP address		*/
	Uint8	  ar_tha[ETH_ALEN];	/* target hardware address	*/
	Uint8	  ar_tip[4];			/* target IP address		*/
};

int arp_init(void);
int arp_add_entry(unsigned char *ha, Uint8 *ip);
int arp_get_eth_addr(Uint32 ip, unsigned char *ha);
int arp_rcv_packet(struct sk_buff *skb);

#endif /* __ARP_H */