s - cadcam read-me.txt

proteus仿真实例大全

LABCENTER PROTEUS TOOL INFORMATION FILE
=======================================

In case of difficulty, please e-mail [e-mail]

Tool set up for Proteus layout 's.LYT'.
CADCAM generated at 14:18:03 on 2007年11月25日.

File List
---------
Top Copper              : s - CADCAM Top Copper.TXT
Bottom Copper           : s - CADCAM Bottom Copper.TXT
Top Silk Screen         : s - CADCAM Top Silk Screen.TXT
Bottom Solder Resist    : s - CADCAM Bottom Solder Resist.TXT
Top SMT Paste Mask      : s - CADCAM Top SMT Paste Mask.TXT
Drill                   : s - CADCAM Drill.TXT

Photoplotter Setup
------------------
Format: RS274X, ASCII, 2.4, imperial, absolute, eob=*, LZO
Notes:  D=Diameter, S=Side, W=Width, H=Height

D10	CIRCLE	D=12th                                      DRAW
D11	CIRCLE	D=50th                                      FLASH
D12	SQUARE	S=50th                                      FLASH
D13	SQUARE	S=60th                                      FLASH
D14	CIRCLE	D=70th                                      FLASH
D15	CIRCLE	D=8th                                       DRAW
D16	SMT	W=70th                H=70th                FLASH
D17	SMT	W=80th                H=80th                FLASH
D18	CIRCLE	D=90th                                      FLASH

NC Drill Setup
--------------
Format: ASCII, 2.4, imperial, absolute, eob=<CR><LF>, no zero suppression.
Notes:  Tool sizes are diameters. Layer sets are in brackets - 0=TOP, 15=BOTTOM, 1-14=INNER.

T01	20th (0-15)
T02	30th (0-15)
T03	25th (0-15)


[END OF FILE]