lcd1602.h

基于单片机的自行车计时

#include <intrins.h>
#include <REGX52.H>
sbit LcdRs		= P2^0;
sbit LcdRw		= P2^1;
sbit LcdEn  	= P2^2;
sfr  DBPort 	= 0x80;		//P0=0x80,P1=0x90,P2=0xA0,P3=0xB0.数据端口
unsigned char LCD_Wait(void)
{
	LcdRs=0;
	LcdRw=1;	_nop_();
	LcdEn=1;	_nop_();
	//while(DBPort&0x80);//在用Proteus仿真时，注意用屏蔽此语句，在调用GotoXY()时，会进入死循环，
	LcdEn=0;
	return DBPort;		
}
#define LCD_COMMAND			0      // Command
#define LCD_DATA			1      // Data
#define LCD_CLEAR_SCREEN	0x01      // 清屏
#define LCD_HOMING  		0x02      // 光标返回原点
void LCD_Write(bit style, unsigned char input)
{
	LcdEn=0;
	LcdRs=style;
	LcdRw=0;		_nop_();
	DBPort=input;	_nop_();//注意顺序
	LcdEn=1;		_nop_();//注意顺序
	LcdEn=0;		_nop_();
	LCD_Wait();	
}
#define LCD_SHOW			0x04    //显示开
#define LCD_HIDE			0x00    //显示关	  

#define LCD_CURSOR			0x02 	//显示光标
#define LCD_NO_CURSOR		0x00    //无光标		     

#define LCD_FLASH			0x01    //光标闪动
#define LCD_NO_FLASH		0x00    //光标不闪动

void LCD_SetDisplay(unsigned char DisplayMode)
{
	LCD_Write(LCD_COMMAND, 0x08|DisplayMode);	
}
#define LCD_AC_UP			0x02
#define LCD_AC_DOWN			0x00      // default

#define LCD_MOVE			0x01      // 画面可平移
#define LCD_NO_MOVE			0x00      //default

void LCD_SetInput(unsigned char InputMode)
{
	LCD_Write(LCD_COMMAND, 0x04|InputMode);
}
void LCD_Initial()
{
	LcdEn=0;
	LCD_Write(LCD_COMMAND,0x38);           //8位数据端口,2行显示,5*7点阵
	LCD_Write(LCD_COMMAND,0x38);
	LCD_SetDisplay(LCD_SHOW|LCD_NO_CURSOR);    //开启显示, 无光标
	LCD_Write(LCD_COMMAND,LCD_CLEAR_SCREEN);   //清屏
	LCD_SetInput(LCD_AC_UP|LCD_NO_MOVE);       //AC递增, 画面不动
}
void GotoXY(unsigned char x, unsigned char y)
{
	if(y==0)
		LCD_Write(LCD_COMMAND,0x80|x);
	if(y==1)
		LCD_Write(LCD_COMMAND,0x80|(x+0x40));	  //这里的“-”被我改成了“+”
}
void Print(unsigned char *str)
{
	while(*str!=0xff)
	{
		LCD_Write(LCD_DATA,*str);
		str++;
	}
}



//LCD_Write(0x08,1);//显示关