sli.docbook

来自「linux下LCD驱动的例子代码」· DOCBOOK 代码 · 共 54 行

<sect1 id="sli-howto">
<title>The sli Driver</title>

<para>
This section talks about using LCDproc with LCD displays that use the
sli chipset.
</para>

<!-- ## Wirz SLI LCD driver ## -->
<sect2 id="Wirz-sli-config">
<title>Configuration in LCDd.conf</title>

<sect3 id="Wirz-sli-config-section">
<title>[sli]</title>

<variablelist>
<varlistentry>
  <term>
    <command>Device=</command>
    <arg choice="plain"><replaceable>DEVICE</replaceable></arg>
  </term>
  <listitem><para>
    Select the output device to use [default: <filename>/dev/lcd</filename>]
  </para></listitem>
</varlistentry>

<varlistentry>
  <term>
    <command>Speed=</command>
    <arg choice="plain">
    <group choice="req">
      <arg choice="plain"><literal>1200</literal></arg>
      <arg choice="plain"><literal>2400</literal></arg>
      <arg choice="plain"><literal>9600</literal></arg>
      <arg choice="plain"><literal><emphasis>19200</emphasis></literal></arg>
      <arg choice="plain"><literal>38400</literal></arg>
      <arg choice="plain"><literal>57600</literal></arg>
      <arg choice="plain"><literal>115200</literal></arg>
    </group>
    </arg>
  </term>
  <listitem><para>
    Set the the baud rate communication with the LCD.
    If not specified, the default is <literal>19200</literal>.
  </para></listitem>
</varlistentry>
</variablelist>

</sect3>

</sect2>

</sect1>