sed1330.docbook

来自「linux下LCD驱动的例子代码」· DOCBOOK 代码 · 共 59 行

<sect1 id="sed1330-howto">
<title>The sed1330 Driver</title>

<para>
This section talks about using LCDproc with LCD displays that use the
sed1330 chipset.
</para>

<!-- ## Seiko Epson 1330 driver ## -->
<sect2 id="sed1330-config">
<title>Configuration in LCDd.conf</title>

<sect3 id="sed1330-config-section">
<title>[sed1330]</title>

<variablelist>
<varlistentry>
  <term>
    <command>Port=</command>
    <arg choice="plain"><replaceable>PORT</replaceable></arg>
  </term>
  <listitem><para>
    Specify the address of the parallel port the LCD is connected to.
    Common values for <replaceable>PORT</replaceable> are <literal>0x278</literal>,
    <literal>0x378</literal> and <literal>0x3BC</literal>.
    If not given, it defaults to <literal>0x278</literal>.
  </para></listitem>
</varlistentry>

<varlistentry>
  <term>
    <command>Type=</command>
    <arg choice="plain">
    <group choice="req">
      <arg choice="plain"><literal>G321D</literal></arg>
      <arg choice="plain"><literal>G121C</literal></arg>
      <arg choice="plain"><literal>G242C</literal></arg>
      <arg choice="plain"><literal>G191D</literal></arg>
      <arg choice="plain"><literal>G2446</literal></arg>
    </group>
    </arg>
  </term>
  <listitem>
    <para>
    Type of LCD module.
    </para>
    <note><para>
      The G321D is the only one that is tested currently.
    </para></note>  
  </listitem>
</varlistentry>
</variablelist>

</sect3>

</sect2>

</sect1>