rfd.cpp

一个Zigbee开放协议栈移植到VC环境下的版本.

/*
    Microchip ZigBee Stack

    Demo RFD

    This demonstration shows how a ZigBee RFD can be set up.  This demo allows
    the PICDEM Z Demostration Board to act as either a "Switching Load Controller"
    (e.g. a light) or a "Switching Remote Control" (e.g. a switch) as defined by
    the Home Controls, Lighting profile.  It is designed to interact with a
    second PICDEM Z programmed with the Demo Coordinator project.

    To give the PICDEM Z "switch" capability, uncomment the I_AM_SWITCH definition
    below.  To give the PICDEM Z "light" capability, uncomment the I_AM_LIGHT
    definition below.  The PICDEM Z may have both capabilities enabled.  Be sure
    that the corresponding Demo Coordinator device is programmed with complementary
    capabilities.  NOTE - for simplicity, the ZigBee simple descriptors for this
    demonstration are fixed.

    If this node is configured as a "switch", it can discover the network address
    of the "light" using two methods.  If the USE_BINDINGS definition is
    uncommented below, then End Device Binding must be performed between the
    "switch" and the "light" before messages can be sent and received successfully.
    If USE_BINDINGS is commented out, then the node will default to the probable
    network address of the other node, and messages may be able to be sent
    immediately.  However, the node will also be capable of performing Device
    Discovery to discover the actual network address of the other node, in case
    the network was formed with alternate short address assignments.  NOTE: The
    USE_BINDINGS definition must be the same in both the RFD and the ZigBee
    Coordinator nodes.

    Switch functionality is as follows:
        RB4, I_AM_SWITCH defined, sends a "toggle" message to the other node's "light"
        RB4, I_AM_SWITCH not defined, no effect
        RB5, USE_BINDINGS defined, sends an End Device Bind request
        RB5, USE_BINDINGS undefined, sends a NWK_ADDR_req for the MAC address specified

    End Device Binding
    ------------------
    If the USE_BINDINGS definition is uncommented, the "switch" will send an
    APS indirect message to toggle the "light".  In order for the message to
    reach its final destination, a binding must be created between the "switch"
    and the "light".  To do this, press RB5 on one PICDEM Z, and then press RB5
    on the other PICDEM Z within 5 seconds.  A message will be displayed indicating
    if binding was successful or not.  Note that End Device Binding is a toggle
    function.  Performing the operation again will unbind the nodes, and messages
    will not reach their final destination.

    Device Discovery
    ----------------
    If the USE_BINDINGS definition is not uncommented, pressing RB5 will send a
    broadcast NWK_ADDR_req message.  The NWK_ADDR_req message contains the MAC
    address of the desired node.  Be sure this address matches the address
    contained in the other node's zigbee.def file.

    NOTE: To speed network formation, ALLOWED_CHANNELS has been set to
    channel 12 only.

 *********************************************************************
 * FileName:        RFD.c
 * Dependencies:
 * Processor:       PIC18F
 * Complier:        MCC18 v3.00 or higher
 * Company:         Microchip Technology, Inc.
 *
 * Software License Agreement
 *
 * The software supplied herewith by Microchip Technology Incorporated
 * (the 揅ompany