53909

来自「神经网络昆斯林的新闻组分类2006」· 代码 · 共 32 行

Path: cantaloupe.srv.cs.cmu.edu!rochester!udel!darwin.sura.net!paladin.american.edu!howland.reston.ans.net!zaphod.mps.ohio-state.edu!saimiri.primate.wisc.edu!usenet.coe.montana.edu!news.u.washington.edu!carson.u.washington.edu!whit
From: [e-mail] (John Whitmore)
Newsgroups: sci.electronics
Subject: Re: Suggestions  on Audio relays ???
Date: 21 Apr 1993 21:00:36 GMT
Organization: University of Washington, Seattle
Lines: 20
Message-ID: <[e-mail]>
References: <[e-mail]>
NNTP-Posting-Host: carson.u.washington.edu

In article <[e-mail]> [e-mail] (Billy Quinn) writes:
>I built a little project using the radio shack 5vdc relays to switch
>audio.  I got pretty bad 'clicks' when the thing switched. 

>	Is there a good relay/relay circuit that I can use for switching
>audio, so that there will be *NO* noise of any kind on the audio lines.

	With relays alone, you will always get a transient when
you abruptly turn ON or OFF any channel.  If you don't want to hear
the transient, use some other device (a photoresistor-output optoisolator
is the usual sort of thing) to gently MUTE the signal, then switch,
THEN remove the power from the lamp in the optoisolator.

	It used to be standard practice to employ photoresistors
in switching audio, because the photoresistor time delay (a few
thousandths of a second) kept any noise in the digital side (which
drives the lamp) from contaminating the audio.  And, the devices
are cheaper than relays.

	John Whitmore