📄 rfc2870.txt
字号:
Network Working Group R. BushRequest for Comments: 2870 VerioObsoletes: 2010 D. KarrenbergBCP: 40 RIPE NCCCategory: Best Current Practice M. Kosters Network Solutions R. Plzak SAIC June 2000 Root Name Server Operational RequirementsStatus of this Memo This document specifies an Internet Best Current Practices for the Internet Community, and requests discussion and suggestions for improvements. Distribution of this memo is unlimited.Copyright Notice Copyright (C) The Internet Society (2000). All Rights Reserved.Abstract As the internet becomes increasingly critical to the world's social and economic infrastructure, attention has rightly focused on the correct, safe, reliable, and secure operation of the internet infrastructure itself. The root domain name servers are seen as a crucial part of that technical infrastructure. The primary focus of this document is to provide guidelines for operation of the root name servers. Other major zone server operators (gTLDs, ccTLDs, major zones) may also find it useful. These guidelines are intended to meet the perceived societal needs without overly prescribing technical details.1. Background The resolution of domain names on the internet is critically dependent on the proper, safe, and secure operation of the root domain name servers. Currently, these dozen or so servers are provided and operated by a very competent and trusted group of volunteers. This document does not propose to change that, but merely to provide formal guidelines so that the community understands how and why this is done.Bush, et al. Best Current Practice [Page 1]RFC 2870 Root Name Server Operational Requirements June 2000 1.1 The Internet Corporation for Assigned Names and Numbers (ICANN) has become responsible for the operation of the root servers. The ICANN has appointed a Root Server System Advisory Committee (RSSAC) to give technical and operational advice to the ICANN board. The ICANN and the RSSAC look to the IETF to provide engineering standards. 1.2 The root servers serve the root, aka ".", zone. Although today some of the root servers also serve some TLDs (top level domains) such as gTLDs (COM, NET, ORG, etc.), infrastructural TLDs such as INT and IN-ADDR.ARPA, and some ccTLDs (country code TLDs, e.g. SE for Sweden), this is likely to change (see 2.5). 1.3 The root servers are neither involved with nor dependent upon the 'whois' data. 1.4 The domain name system has proven to be sufficiently robust that we are confident that the, presumably temporary, loss of most of the root servers should not significantly affect operation of the internet. 1.5 Experience has shown that the internet is quite vulnerable to incorrect data in the root zone or TLDs. Hence authentication, validation, and security of these data are of great concern.2. The Servers Themselves The following are requirements for the technical details of the root servers themselves: 2.1 It would be short-sighted of this document to specify particular hardware, operating systems, or name serving software. Variations in these areas would actually add overall robustness. 2.2 Each server MUST run software which correctly implements the IETF standards for the DNS, currently [RFC1035] [RFC2181]. While there are no formal test suites for standards compliance, the maintainers of software used on root servers are expected to take all reasonable actions to conform to the IETF's then current documented expectations. 2.3 At any time, each server MUST be able to handle a load of requests for root data which is three times the measured peak of such requests on the most loaded server in then current normal conditions. This is usually expressed in requests per second. This is intended to ensure continued operation of root services should two thirds of the servers be taken out of operation, whether by intent, accident, or malice.Bush, et al. Best Current Practice [Page 2]RFC 2870 Root Name Server Operational Requirements June 2000 2.4 Each root server should have sufficient connectivity to the internet to support the bandwidth needs of the above requirement. Connectivity to the internet SHOULD be as diverse as possible. Root servers SHOULD have mechanisms in place to accept IP connectivity to the root server from any internet provider delivering connectivity at their own cost. 2.5 Servers MUST provide authoritative responses only from the zones they serve. The servers MUST disable recursive lookup, forwarding, or any other function that may allow them to provide cached answers. They also MUST NOT provide secondary service for any zones other than the root and root-servers.net zones. These restrictions help prevent undue load on the root servers and reduce the chance of their caching incorrect data. 2.6 Root servers MUST answer queries from any internet host, i.e. may not block root name resolution from any valid IP address, except in the case of queries causing operational problems, in which case the blocking SHOULD last only as long as the problem, and be as specific as reasonably possible. 2.7 Root servers SHOULD NOT answer AXFR, or other zone transfer, queries from clients other than other root servers. This restriction is intended to, among other things, prevent unnecessary load on the root servers as advice has been heard such as "To avoid having a corruptible cache, make your server a stealth secondary for the root zone." The root servers MAY put the root zone up for ftp or other access on one or more less critical servers. 2.8 Servers MUST generate checksums when sending UDP datagrams and MUST verify checksums when receiving UDP datagrams containing a non-zero checksum.3. Security Considerations The servers need both physical and protocol security as well as unambiguous authentication of their responses. 3.1 Physical security MUST be ensured in a manner expected of data centers critical to a major enterprise. 3.1.1 Whether or not the overall site in which a root server is located has access control, the specific area in which the root server is located MUST have positive access control, i.e. the number of individuals permitted access to the area MUST be limited, controlled, and recorded. At aBush, et al. Best Current Practice [Page 3]RFC 2870 Root Name Server Operational Requirements June 2000 minimum, control measures SHOULD be either mechanical or electronic locks. Physical security MAY be enhanced by the use of intrusion detection and motion sensors, multiple serial access points, security personnel, etc. 3.1.2 Unless there is documentable experience that the local power grid is more reliable than the MTBF of a UPS (i.e. five to ten years), power continuity for at least 48 hours MUST be assured, whether through on-site batteries, on- site power generation, or some combination thereof. This MUST supply the server itself, as well as the infrastructure necessary to connect the server to the internet. There MUST be procedures which ensure that power fallback mechanisms and supplies are tested no less frequently than the specifications and recommendations of the manufacturer. 3.1.3 Fire detection and/or retardation MUST be provided. 3.1.4 Provision MUST be made for rapid return to operation after a system outage. This SHOULD involve backup of systems software and configuration. But SHOULD also involve backup hardware which is pre-configured and ready to take over operation, which MAY require manual procedures. 3.2 Network security should be of the level provided for critical infrastructure of a major commercial enterprise. 3.2.1 The root servers themselves MUST NOT provide services other than root name service e.g. remote internet protocols such as http, telnet, rlogin, ftp, etc. The only login accounts permitted should be for the server administrator(s). "Root" or "privileged user" access MUST NOT be permitted except through an intermediate user account. Servers MUST have a secure mechanism for remote administrative access and maintenance. Failures happen; given the 24x7 support requirement (per 4.5), there will be times when something breaks badly enough that senior wizards will have to connect remotely. Remote logins MUST be protected by a secure means that is strongly authenticated and encrypted, and sites from which remote login is allowed MUST be protected and hardened. 3.2.2 Root name servers SHOULD NOT trust other hosts, except secondary servers trusting the primary server, for matters of authentication, encryption keys, or other access orBush, et al. Best Current Practice [Page 4]RFC 2870 Root Name Server Operational Requirements June 2000 security information. If a root operator uses kerberos authentication to manage access to the root server, then the associated kerberos key server MUST be protected with the same prudence as the root server itself. This applies to all related services which are trusted in any manner. 3.2.3 The LAN segment(s) on which a root server is homed MUST NOT also home crackable hosts. I.e. the LAN segments should be switched or routed so there is no possibility of masquerading. Some LAN switches aren't suitable for security purposes, there have been published attacks on their filtering. While these can often be prevented by careful configuration, extreme prudence is recommended. It is best if the LAN segment simply does not have any other hosts on it. 3.2.4 The LAN segment(s) on which a root server is homed SHOULD be separately firewalled or packet filtered to discourage network access to any port other than those needed for name service. 3.2.5 The root servers SHOULD have their clocks synchronized via NTP [RFC1305] [RFC2030] or similar mechanisms, in as secure manner as possible. For this purpose, servers and their associated firewalls SHOULD allow the root servers to be NTP clients. Root servers MUST NOT act as NTP peers or servers. 3.2.6 All attempts at intrusion or other compromise SHOULD be logged, and all such logs from all root servers SHOULD be analyzed by a cooperative security team communicating with all server operators to look for patterns, serious attempts, etc. Servers SHOULD log in GMT to facilitate log comparison. 3.2.7 Server logging SHOULD be to separate hosts which SHOULD be protected similarly to the root servers themselves. 3.2.8 The server SHOULD be protected from attacks based on source routing. The server MUST NOT rely on address- or name-based authentication. 3.2.9 The network on which the server is homed SHOULD have in-addr.arpa service. 3.3 Protocol authentication and security are required to ensure that data presented by the root servers are those created by those authorized to maintain the root zone data.Bush, et al. Best Current Practice [Page 5]
⌨️ 快捷键说明
复制代码
Ctrl + C
搜索代码
Ctrl + F
全屏模式
F11
切换主题
Ctrl + Shift + D
显示快捷键
?
增大字号
Ctrl + =
减小字号
Ctrl + -