📄 rfc1520.txt
字号:
Network Working Group Y. RekhterRequest for Comments: 1520 T.J. Watson Research Center, IBM Corp.Category: Informational C. Topolcic CNRI September 1993 Exchanging Routing Information Across Provider Boundaries in the CIDR EnvironmentStatus of this Memo This memo provides information for the Internet community. It does not specify an Internet standard. Distribution of this memo is unlimited.1. Introduction Classless Inter-Domain Routing (CIDR) has been adopted as a solution to the scaling problem in the Internet. The overall CIDR architecture is described in [1]. The architecture for IP address assignment with CIDR is covered in [2] and [3]. The inter-domain routing protocols that are capable of supporting CIDR are covered in [4], [5], and [6]. The purpose of this document is twofold. First, it describes various alternatives for exchanging inter-domain routing information across domain boundaries, where one of the peering domain is CIDR-capable and another is not. Second, it addresses the implications of running CIDR-capable inter-domain routing protocols (e.g., BGP-4, IDRP) on intra-domain routing. This document is not intended to cover all the cases (either real or imaginable). Rather, it focuses on what are viewed to be the most common cases. We expect that individual service providers will use this document as guidelines in establishing their specific operational plans for the transition to CIDR. The concepts of "network service provider" and "network service subscriber" were introduced in [3]. For the sake of brevity, we will use the term "provider" or "service provider" here to mean either "network service provider" or "network service subscriber", since for the most part, the distinction is not important to this discussion. Furthermore, we use the same terms to refer to the network and to the organization that operates the network. We feel that the context makes it amply clear whether we are talking about hardware or people, and defining different terms would only make this paper harder to read.Rekhter & Topolcic [Page 1]RFC 1520 CIDR Provider Information Exchange September 1993 This document defines a CIDR-capable provider as the provider that can perform correct IP packet forwarding (both internally and to other adjacent providers) when the inter-domain routing information acquired by the provider is expressed solely in terms of IP address prefixes (with no distinction between A/B/C class of addresses). This document defines CIDR-capable forwarding as the ability of a router to maintain its forwarding table and to perform correct forwarding of IP packets without making any assumptions about the class of IP addresses. This document defines CIDR reachability information as reachability information that may violate any assumptions about the class of IP addresses. For instance, a contiguous block of class C networks expressed as a single IP address prefix constitutes CIDR reachability information.2. Taxonomy of Service Providers For the purpose of this document we partition all service providers into the following categories, based on the type and volume of inter-domain routing information a provider needs to acquire in order to meet its service requirements: - Requirements imposed on a service provider preclude it from using Default inter-domain route(s) -- we'll refer to such a pqrovider as a Type 1 provider. - Requirements imposed on a service provider allow it to rely on using one or more Default routes for inter-domain routing, but this information must be supplemented by requiring the provider to acquire a large percentage of total Internet routing information -- we'll refer to such a provider as a Type 2 provider. - Requirements imposed on a service provider allow it to rely on using one or more Default routes for inter-domain routing; however, to meet its service requirements the provider must supplement Default route(s) by acquiring a small percentage of total Internet routing information -- we'll refer to such a provider as a Type 3 provider. - Requirements imposed on a service provider allow it to rely solely on using one or more Default routes for inter-domain routing; no other inter-domain routing information need to be acquired -- we'll refer to such a provider as a Type 4 provider.Rekhter & Topolcic [Page 2]RFC 1520 CIDR Provider Information Exchange September 19933. Assumptions on Deployment of CIDR in the Internet The document assumes that the CIDR deployment in the Internet will proceed as a three phase process. In the first phase all the major service providers will become CIDR- capable. Specifically, all the providers that can't rely on using Default route(s) for inter-domain routing (Type 1 providers) are expected to deploy BGP-4 and transition to CIDR during this phase. It is expected that CIDR reachability information will first appear in the Internet upon transition of all Type 1 service providers to CIDR. The second phase will commence upon completion of the first phase. During the second phase other service providers that are connected to the service providers that were transitioned to CIDR during the first phase will become CIDR-capable. Specifically, during the second phase it is expected that most of the providers that need to acquire a large percentage of the total Internet routing information (Type 2 provider) will become CIDR-capable. In addition, during the second phase some of the Type 3 providers may become CIDR-capable as well. This plan was agreed to by a number of major providers [8]. NSFNET's steps to implement this plan are described in [9]. Finally, during the third phase the rest of the Type 3 providers and most of the Type 4 providers will transition to CIDR. It is expected that the duration of the first phase will be significantly shorter than duration of the second phase. Likewise, the duration of the second phase is expected to be shorter than the duration of the third phase. This document addresses the need for service providers to exchange inter-domain routing information during the second and third phases of this deployment. During these phases, some providers will be CIDR-capable, and others will not. Hence this document considers routing exchanges where one of the peers is CIDR-capable and the other is CIDR-incapable.4. Implications of CIDR on Interior Routing A CIDR-capable service provider can use the following two techniques to distribute exterior routing information to all of its routers (both interior and border): - utilize internal BGP/IDRP between all the routers - use CIDR-capable IGPs (e.g., OSPF, IS-IS, RIP2)Rekhter & Topolcic [Page 3]RFC 1520 CIDR Provider Information Exchange September 1993 The first technique doesn't impose any addition requirements on the IGP within the provider. Additional information on implementing the first option is presented in [5] (see Section A.2.4). The second technique allows the provider to reduce the utilization of internal BGP/IDRP, but imposes specific requirements on the intra- domain routing. It also requires the ability to inject inter-domain routing information (acquired either via BGP or IDRP) into the intra-domain routing. Additional details on implementing the second option are provided in [7]. It is not expected that all the features enumerated in [7] will be widely needed. Therefore, it would be highly desirable to prioritize the features. Note that both of these techniques imply that all the routers within a CIDR-capable service provider need to be capable of CIDR-based forwarding. Discussion of which of the two techniques should be preferred is outside the scope of this document.5. Exchanging Inter-Domain Routing Information At each phase during the transition to CIDR one of the essential aspects of the Internet operations will be the exchange of inter- domain routing information between CIDR-capable providers and CIDR- incapable provider. When exchanging inter-domain routing information between a CIDR- capable provider and a CIDR-incapable provider, it is of utmost importance to take into account the view each side wants the other to present. This view has two distinct aspects: - the type of routing information exchanged (i.e., Default route, traditional (non-CIDR) reachability information, CIDR reachability information) - routing information processing each side needs to do to maintain these views (e.g., ability to perform aggregation, ability to perform controlled de-aggregation) The exchange of inter-domain routing information is expected to be controlled by bilateral agreements between the directly connected service providers. Consequently, the views each side wants of the other are expected to form an essential component of such agreements. To facilitate troubleshooting and problem isolation, the bilateral agreements should be made accessible to other providers. One way to accomplish this is by placing them in a generally accessibleRekhter & Topolcic [Page 4]RFC 1520 CIDR Provider Information Exchange September 1993 database. The details of how this can be implemented are outside the scope of this document. A possible way to accomplish this is described in [9]. Since the exchange of inter-domain routing information across provider boundaries occurs on a per peer basis, a border router is expected to provide necessary mechanisms (e.g., configuration) that will control exchange and processing of this information on a per peer basis. In the following sections we describe possible scenarios for exchanging inter-domain routing information. It is always assumed that one side is CIDR-capable and the other is not.5.1 Exchanging Inter-Domain Routing Information between CIDR-capable providers and CIDR-incapable Type 2 (default with large proportion of explicit routes) providers We expect the border router(s) within a CIDR-capable provider to be capable of aggregating inter-domain routing information they receive from a CIDR-incapable Type 2 provider. The aggregation is expected to be governed and controlled via a bilateral agreement. Specifically, the CIDR capable provider is expected to aggregate only the information the other side (the CIDR-incapable provider)
⌨️ 快捷键说明
复制代码
Ctrl + C
搜索代码
Ctrl + F
全屏模式
F11
切换主题
Ctrl + Shift + D
显示快捷键
?
增大字号
Ctrl + =
减小字号
Ctrl + -