⭐ 欢迎来到虫虫下载站! | 📦 资源下载 📁 资源专辑 ℹ️ 关于我们
⭐ 虫虫下载站

📄 rfc1093.txt

📁 著名的RFC文档,其中有一些文档是已经翻译成中文的的.
💻 TXT
📖 第 1 页 / 共 2 页
字号:
Network Working Group                                         H.W. BraunRequest for Comments: 1093                                         Merit                                                           February 1989                    The NSFNET Routing ArchitectureStatus of this Memo   This document describes the routing architecture for the NSFNET   centered around the new NSFNET Backbone, with specific emphasis on   the interface between the backbone and its attached networks.   Distribution of this memo is unlimited.Introduction   This document describes the routing architecture for the NSFNET   centered around the new NSFNET Backbone, with specific emphasis on   the interface between the backbone and its attached networks.  It   reflects and augments thoughts described in [1], discussions during   the Internet Engineering Task Force meeting at the San Diego   Supercomputing Center in March 1988, discussions on mailing lists,   especially on a backbone/regional network working group mailing list,   and a final discussion held at the IBM T.J. Watson Research Center in   Yorktown, NY, on the 21st of March 1988.  The Yorktown meeting was   attended by Hans-Werner Braun (Merit), Scott Brim (Cornell   University), Mark Fedor (NYSERNet), Jeff Honig (Cornell University),   and Jacob Rekhter (IBM).  Thanks also to: Milo Medin (NASA), John Moy   (Proteon) and Greg Satz (Cisco) for discussing this document by email   and/or phone.   Understanding of [1] is highly recommended prior to reading this   document.1. Routing Overview   The new NSFNET backbone forms the core of the overall NSFNET, which   connects to regional networks (or regional backbones) as well as to   peer networks (other backbones like the NASA Science Network or the   ARPANET).  The NSFNET core uses a SPF based internal routing   protocol, adapted from the IS-IS protocol submitted by ANSI for   standardization to the ISO.  The ANSI IS-IS protocol is based upon   work done at Digital Equipment Corporation.  Its adaptation to the   Internet environment requires additional definitions, most notably to   the addressing structure, which will be described in a later   document.  This adaptation was largely done by Jacob Rekhter of IBM   Research in Yorktown, NY. The RCP/PSP routing architecture was   largely implemented by Rick Boivie and his colleagues at IBM TCS inBraun                                                           [Page 1]RFC 1093              NSFNET Routing Architecture          February 1989   Milford, CT.  The adaptation of EGP to the NSS routing code and the   new requirements was done jointly by Jeff Honig (who spent about a   week to work on this at IBM Research) and Jacob Rekhter.  Jeff is   integrating the changes done for the new EGP requirements into the   "gated" distributions.   The IGP derives routing tables from Internet address information.   This information is flooded throughout the NSFNET core, and the   individual NSS nodes create or update their routing information after   running the SPF algorithm over the flooded information.  A detailed   description of the NSFNET backbone IGP will be documented in a future   document.   The routing interface between the NSFNET core and regional backbones   as well as peer networks utilizes the Exterior Gateway Protocol   (EGP).  The EGP/IGP consistency and integrity at the interface points   is ensured by filtering mechanisms according to individual nodal   routing policy data bases [1].  EGP is selected as the routing   interface of choice between the NSFNET backbone and its regional   attachments due to its widespread implementation as well its ability   to utilize autonomous system designators and to allow for effective   firewalls between systems.  In the longer run the hope is to replace   the EGP interface with a new inter Autonomous System protocol. Such a   new protocol should also allow to move the filtering of network   numbers or Autonomous Network number groups to the regional gateways   in order for the regional gateways to decide as to what routing   information they wish to receive.   A general model is to ensure consistent routing information between   peer networks.  This means that, e.g., the NSFNET core will have the   same sets of Internet network numbers in its routing tables as are   present in the ARPANET core.  However, the redistribution of this   routing information is tightly controlled and based on Autonomous   System numbers.  For example, ARPANET routes with the ARPANET   Autonomous System number will not be redistributed into regional or   other peer networks.  If an NSFNET internal path exists to such a   network known to the ARPANET it may be redistributed into regional   networks, subject to further policy verification. Generally it may be   necessary to have different trust models for peer and subordinate   networks, while giving a greater level of trust to peer networks.   The described use of EGP, which is further elaborated on in [1]   requires bidirectional translation of network information between the   IGP in use and EGP.2. Conclusions reached during the discussions   The following conclusions were reached during the meeting and inBraun                                                           [Page 2]RFC 1093              NSFNET Routing Architecture          February 1989   subsequent discussions:      No DDN-only routes (ARPANET/MILNET) shall be announced into the      regional backbones.  This is a specific case of the ability to      suppress information from specific Autonomous Systems, as      described later.      Regional backbones are required to use an unique Autonomous System      number.  Announcements from non-sanctioned autonomous systems,      relative to a particular site, will not be believed and will      instead trigger an alarm to the Network Operations Center.      Regional backbone attachments must not require routes to local      subnets.  This means that the locally attached network needs to      use a flat space, without subnet bits, at least from the NSS point      of view.  The reason for this is that the EGP information      exchanged between the regional gateway and the NSS cannot include      subnet information. Therefore the NSS has no knowledge of remote      subnets.  The safest way to get around this limitation is to use a      non-subnetted network (like a separate Class-C network) at the      interface between a regional backbone and the NSFNET backbone.      The other way is to use Proxy-ARP while having just the NSS think      that the network is not subnetted. In the latter case care must be      taken so that the E-PSP uses the proper local IP broadcast      address.      Routing information received by the NSS from regional gateways      will be verified on both network number and autonomous system      number.      Metric reconstitution is done on a per-network basis.  The NSS      will construct the fixed metric it will use for a given network      number from its internal data base.  Network metrics given to the      NSS via EGP will be ignored.  The metrics used are a result of an      ordered list of preferred paths as supplied by the regional      backbones and the attached campuses.  This metric is of relevance      only to the NSFNET core itself.  The mechanisms are further      explained in [1].      Global metric reconstitution by Autonomous System numbers is      necessary in specific cases, such as peer networks.  An example is      that ARPANET routes will be reconstituted to a global metric, as      determined by the NSS.      EGP announcements into regional networks will use a fixed metric.      The metric used shall be "128."  The 128-metric is somewhat      arbitrarily chosen to be high enough so that a regional backbone      will get a metric high enough from the NSFNET Core AS to allow aBraun                                                           [Page 3]RFC 1093              NSFNET Routing Architecture          February 1989      comparison against other (most likely internal) routes. "128" is      also consistent with [2].      Peer network routes (e.g., ARPANET routes) are propagated through      the NSS structure.      No DEFAULT routing information is distributed within the NSFNET      backbone, as the NSFNET core has the combined routing knowledge of      the attached regional and peer networks.      We do not expect the requirement for damping of routing update      frequencies, at least initially.  The frequency of net up/down      changes combined with the available bandwidth and CPU capacity do      not let the frequency of SPF floodings appear as being a major      problem.  Simple metric changes as heard by a NSS via EGP will not      trigger updates.      An allowed list of Source Autonomous System information will be      used to convert from the IGP to EGP, on a Destination Autonomous      System number basis, to allow for specific exclusion of definable      remote Autonomous System information.      EGP must only announce networks for which the preferred path is      via the IGP.  This means in particular that the EGP peer will      never announce via EGP what it learned via EGP on the same      interface, not even if the information was received from a third      EGP peer.  This will avoid the back-distribution of information      learned via that same interface.  The EGP peers of regional      gateways must only announce information belonging to their own      Autonomous System.      EGP will be used in interior mode only.      The regional backbones are responsible for generating DEFAULT      routing information at their option.  One possibility is to      generate an IGP default on a peer base as long as the NSS EGP      connection is working.  The EGP information will not include a      special indication for DEFAULT.      It is highly desirable to have direct peer-peer connections, to      ease the implementation of a consistent routing data base.      A single Autonomous System number may not be used with two E-PSPs      at the same time as long as the two E-PSP's belong to the same      NSS.  Otherwise the same Autonomous System number can be used from      multiple points of attachment to the backbone and therefore can      talk to more than one E-PSP.  However, this may result in      suboptimal routing unless multiple announcements are properlyBraun                                                           [Page 4]RFC 1093              NSFNET Routing Architecture          February 1989      engineered according to [1].      The administrator of the regional networks should be warned that      improper routing implementations within the region may create      suboptimal regional routing by using this restriction if no care      is taken in that:         Only networks belonging to their own Autonomous System get         preferred over NSFNET backbone paths; this may extend to a         larger virtual Autonomous System if backdoor paths are         effectively implemented.         IGP implementations should not echo back routing information         heard via the same path.         If two regional networks decide to implement a backdoor         connection between themselves, then the backdoor must have a         firewall in so that information about their own Autonomous         System cannot flow in from the other Autonomous System.  That         is, a regional network must not allow information about         networks that are interior to its Autonomous System to enter         via exterior routes.  Likewise, if a regional network is         connected to the NSFNET via two NSS connections, the NSS cannot         send back information about the Autonomous System into the

⌨️ 快捷键说明

复制代码 Ctrl + C
搜索代码 Ctrl + F
全屏模式 F11
切换主题 Ctrl + Shift + D
显示快捷键 ?
增大字号 Ctrl + =
减小字号 Ctrl + -