bspopts.h.in

RTEMS (Real-Time Executive for Multiprocessor Systems) is a free open source real-time operating sys

/* include/bspopts.h.in.  Generated from configure.ac by autoheader.  */

/* (BSP--console driver) Must be defined to be one of SMC1_MINOR, SMC2_MINOR,
   SCC2_MINOR, SCC3_MINOR, or SCC4_MINOR. Determines which device will be
   registered as /dev/console. */
#undef CONSOLE_MINOR

/* If defined, the data cache will be enabled after address translation is
   turned on. */
#undef DATA_CACHE_ENABLE

/* used by irq/irq.c */
#undef DISPATCH_HANDLER_STAT

/* If defined, the instruction cache will be enabled after address translation
   is turned on. */
#undef INSTRUCTION_CACHE_ENABLE

/* Define to the address where bug reports for this package should be sent. */
#undef PACKAGE_BUGREPORT

/* Define to the full name of this package. */
#undef PACKAGE_NAME

/* Define to the full name and version of this package. */
#undef PACKAGE_STRING

/* Define to the one symbol short name of this package. */
#undef PACKAGE_TARNAME

/* Define to the version of this package. */
#undef PACKAGE_VERSION

/* (BSP--console driver) Must be defined to be one of SMC1_MINOR, SMC2_MINOR,
   SCC2_MINOR, SCC3_MINOR, or SCC4_MINOR. Determines which device is used for
   output by printk(). If the port that printk() uses is also used for other
   I/O (e.g. if PRINTK_MINOR == \$CONSOLE_MINOR), then both ports should use
   the same type of I/O, otherwise the drivers will likely conflict with each
   other. */
#undef PRINTK_MINOR

/* (BSP--console driver) Define to 0 or 1 if you want polled I/O performed by
   RTEMS. Define to 1 if you want interrupt-driven performed by RTEMS. Define
   to 2 if you want polled I/O performed by EPPCBug. There is no provision to
   have a mix of interrupt-driven and polled I/O ports, except that the printk
   port may use a different mode from the other ports. If this is done, do not
   open the printk port from an RTEMS application. With EPPCBug 1.1, if mode 2
   is selected, CONSOLE_MINOR must be set to SMC1_MINOR. This is a deficiency
   of the firmware: it does not perform serial I/O on any port other than its
   default debug port, which must be SMC1. */
#undef UARTS_IO_MODE

/* Define to 1 if you want termios support for every port. Termios support is
   independent of the choice of UART I/O mode. */
#undef UARTS_USE_TERMIOS