p&e_fcs_linker.prm

来自「GZ60的can通信源程序 用c语言编写」· PRM 代码 · 共 31 行

/* This is a linker parameter file for the GZ60 */
NAMES END /* CodeWarrior will pass all the needed files to the linker by command line. But here you may add your own files too. */

SEGMENTS /* here all RAM/ROM areas of the device are listed. Used in PLACEMENT below. */
  Z_RAM     = READ_WRITE 0x0040 TO 0x00EF;
  RAM1      = READ_WRITE 0x0100 TO 0x043F;
  RAM2      = READ_WRITE 0x0580 TO 0x097F;
  ROM1      = READ_ONLY  0x0462 TO 0x04FF;
  ROM2      = READ_ONLY  0x0980 TO 0x1B7F;
  ROM3      = READ_ONLY  0x1E20 TO 0xFDFF;
//OSVECTORS = READ_ONLY  0xFFCC TO 0xFFFF;  /* OSEK interrupt vectors (use your vector.o) */  
END

PLACEMENT /* here all predefined and user segments are placed into the SEGMENTS defined above. */
//.ostext,                                      /* OSEK */
  DEFAULT_ROM                   INTO /*ROM1, ROM2,*/ ROM3;  /* in case you want to use ROM1/ROM2 here as well, add option -OnB=b to the compiler. */
  DEFAULT_RAM                   INTO RAM1, RAM2;
  _DATA_ZEROPAGE, MY_ZEROPAGE   INTO Z_RAM;
//VECTORS_DATA                  INTO OSVECTORS; /* OSEK */
END

ENTRIES /* keep the following unreferenced variables */
//_vectab OsBuildNumber /* OSEK */
END

STACKSIZE 0x50

VECTOR 0 _Startup /* reset vector: this is the default entry point for a C/C++ application. */
//VECTOR 0 Entry  /* reset vector: this is the default entry point for a Assembly application. */
//INIT Entry      /* for assembly applications: that this is as well the initialization entry point */