config.in

Linux内核源代码 为压缩文件 是<<Linux内核>>一书中的源代码

# $Id: No. :) $

mainmenu_option next_comment
comment 'Memory Technology Devices (MTD)'

tristate 'Memory Technology Device (MTD) support' CONFIG_MTD

if [ "$CONFIG_MTD" = "y" -o "$CONFIG_MTD" = "m" ]; then
   bool 'Debugging' CONFIG_MTD_DEBUG
   if [ "$CONFIG_MTD_DEBUG" = "y" ]; then
      int '  Debugging verbosity (0 = quiet, 3 = noisy)' CONFIG_MTD_DEBUG_VERBOSE 0
   fi

comment 'Disk-On-Chip Device Drivers'
   dep_tristate '  M-Systems Disk-On-Chip 1000' CONFIG_MTD_DOC1000 $CONFIG_MTD
   dep_tristate '  M-Systems Disk-On-Chip 2000 and Millennium' CONFIG_MTD_DOC2000 $CONFIG_MTD
   dep_tristate '  M-Systems Disk-On-Chip Millennium-only alternative driver' CONFIG_MTD_DOC2001 $CONFIG_MTD
   if [ "$CONFIG_MTD_DOC2001" = "y" -o "$CONFIG_MTD_DOC2000" = "y" ]; then
      define_tristate CONFIG_MTD_DOCPROBE y
   else
      if [ "$CONFIG_MTD_DOC2001" = "m" -o "$CONFIG_MTD_DOC2000" = "m" ]; then
	 define_tristate CONFIG_MTD_DOCPROBE m
      else
	 define_tristate CONFIG_MTD_DOCPROBE n
      fi
   fi
   if [ "$CONFIG_MTD_DOCPROBE" = "y" -o "$CONFIG_MTD_DOCPROBE" = "m" ]; then
      hex  '    Physical address of DiskOnChip' CONFIG_MTD_DOCPROBE_ADDRESS 0x0000
      bool '    Probe high addresses' CONFIG_MTD_DOCPROBE_HIGH
      bool '    Probe for 0x55 0xAA BIOS Extension Signature' CONFIG_MTD_DOCPROBE_55AA
   fi

comment 'RAM/ROM Device Drivers'
   dep_tristate '  Use extra onboard system memory as MTD device' CONFIG_MTD_SLRAM $CONFIG_MTD
   dep_tristate '  Ramix PMC551 PCI Mezzanine ram card support' CONFIG_MTD_PMC551 $CONFIG_MTD $CONFIG_PCI
   if [ "$CONFIG_MTD_PMC551" != "n" ]; then
      bool '    PMC551 256M DRAM Bugfix' CONFIG_MTD_PMC551_BUGFIX
      bool '    PMC551 Debugging' CONFIG_MTD_PMC551_DEBUG
   fi
   dep_tristate '  Debugging RAM test driver' CONFIG_MTD_MTDRAM $CONFIG_MTD
   if [ "$CONFIG_MTD_MTDRAM" != "n" ]; then
      int 'Device size in kB' CONFIG_MTDRAM_TOTAL_SIZE 4096
      int 'Size of the erase sectors in kB' CONFIG_MTDRAM_ERASE_SIZE 128
   fi

comment 'Linearly Mapped Flash Device Drivers'
   dep_tristate '  Common Flash Interface (CFI) support' CONFIG_MTD_CFI $CONFIG_MTD
   dep_tristate '    CFI support for Intel/Sharp Extended Command Set chips' CONFIG_MTD_CFI_INTELEXT $CONFIG_MTD_CFI
   dep_tristate '    CFI support for AMD/Fujitsu Standard Command Set chips' CONFIG_MTD_CFI_AMDSTD $CONFIG_MTD_CFI
   dep_tristate '  Support for RAM chips in bus mapping' CONFIG_MTD_RAM $CONFIG_MTD
   dep_tristate '  Support for ROM chips in bus mapping' CONFIG_MTD_ROM $CONFIG_MTD

# These will later become config-options
define_bool CONFIG_MTD_JEDEC n

   dep_tristate '  Flash chip mapping in physical memory' CONFIG_MTD_PHYSMAP $CONFIG_MTD_CFI
   if [ "$CONFIG_MTD_PHYSMAP" = "y" -o "$CONFIG_MTD_PHYSMAP" = "m" ]; then
      hex '    Physical start location of flash chip mapping' CONFIG_MTD_PHYSMAP_START 0x8000000
      hex '    Physical length of flash chip mapping' CONFIG_MTD_PHYSMAP_LEN 0x4000000
      int '    Bus width in octets' CONFIG_MTD_PHYSMAP_BUSWIDTH 2
   fi

comment 'Drivers for chip mappings'
   dep_tristate '  Flash chip mapping on Mixcom piggyback card' CONFIG_MTD_MIXMEM $CONFIG_MTD_JEDEC
   dep_tristate '  Flash chip mapping on Nora' CONFIG_MTD_NORA $CONFIG_MTD_CFI
   dep_tristate '  Flash chip mapping on Octagon 5066 SBC' CONFIG_MTD_OCTAGON $CONFIG_MTD_JEDEC
   dep_tristate '  Flash chip mapping on Photron PNC-2000' CONFIG_MTD_PNC2000 $CONFIG_MTD_CFI
   dep_tristate '  Flash chip mapping on RPXLite PPC board' CONFIG_MTD_RPXLITE $CONFIG_MTD_CFI
   dep_tristate '  Flash chip mapping on Tempustech VMAX SBC301' CONFIG_MTD_VMAX $CONFIG_MTD_JEDEC

comment 'User modules and translation layers for MTD devices'
   dep_tristate '  Direct chardevice access to MTD devices' CONFIG_MTD_CHAR $CONFIG_MTD
   dep_tristate '  Caching blockdevice access to MTD devices' CONFIG_MTD_BLOCK $CONFIG_MTD
   dep_tristate '  FTL (Flash Translation Layer) support' CONFIG_FTL $CONFIG_MTD
   dep_tristate '  NFTL (NAND Flash Translation Layer) support' CONFIG_NFTL $CONFIG_MTD
   if [ "$CONFIG_NFTL" = "y" -o "$CONFIG_NFTL" = "m" ]; then
      bool '    Write support for NFTL (BETA)' CONFIG_NFTL_RW
   fi
fi

endmenu