abstract.txt

掏美元培训得来的某外国公司推广keil ARM 和LPC2100的源码。

This examples shows nesting of classic interrupt functions on the
MCB2100 Board.  It uses two interrupts Timer0 (tc0) and external 
interrupt (EINT1 input assigned to GPIO 0.14 and connected to INT1 
push button on Keil MCB2100 when jumper INT1 is ON).

The interrupt pin is configured edge sensitive. Whenever you release 
the push button a counter is incremented that is output to the LED's 
connected to GPIO 1.16 - 1.22. Inside the EINT function, there is a
long delay function that is just implemented to waste CPU time.

The Timer interrupt is called every 100uSec and increments the variable 
SecondCnt every second. GPIO 1.23 outputs an one second pulse that is derived 
from this timer interupt.

The project is available configured for two targets:

Simulator:  runs without hardware on uVision Simulator
MCB2100:    runs on Keil MCB2100 (with ULINK as debugger/programmer)

Under Simulation you may use the Logic Analyzer to review the operation
of the program. A debug function generates 100ms interrupt pulses at 
debugger startup.

You may manually generate interrupts by changing the state of GPIO 0.14
under Peripherals - GPIO - Port 0

A simulator script provides a signal function that generates input
pulses on GPIO PORT0.14. This signal function may be triggered from
buttons in the Toolbox (opens with View - Toolbox).