uart0_tx

这是本人毕业设计的源码部分,主要完成了步进电机的智能控制:采用AVR系列单片机做主空单元,可红外遥控,其中脉冲分配由CPLD实现.

//ICC-AVR application builder : 2006-5-29 10:41:16
// Target : M8
// Crystal: 8.0000Mhz

#include <iom8v.h>
#include <macros.h>

void port_init(void)
{
 PORTB = 0x00;
 DDRB  = 0x00;
 PORTC = 0x00; //m103 output only
 DDRC  = 0x00;
 PORTD = 0x00;
 DDRD  = 0x00;
}

//TIMER1 initialize - prescale:Stop
// WGM: 4) CTC, TOP=OCRnA
// desired value: 38.4KHz
// actual value: Out of range
void timer1_init(void)
{
 TCCR1B = 0x00; //stop
 TCNT1H = 0x00 /*INVALID SETTING*/; //setup
 TCNT1L = 0x00 /*INVALID SETTING*/;
 OCR1AH = 0x00 /*INVALID SETTING*/;
 OCR1AL = 0x00 /*INVALID SETTING*/;
 OCR1BH = 0x00 /*INVALID SETTING*/;
 OCR1BL = 0x00 /*INVALID SETTING*/;
 ICR1H  = 0x00 /*INVALID SETTING*/;
 ICR1L  = 0x00 /*INVALID SETTING*/;
 TCCR1A = 0x40;
 TCCR1B = 0x08; //start Timer
}

//UART0 initialize
// desired baud rate: 2400
// actual: baud rate:2404 (0.2%)
// char size: 8 bit
// parity: Odd
void uart0_init(void)
{
 UCSRB = 0x00; //disable while setting baud rate
 UCSRA = 0x00;
 UCSRC = BIT(URSEL) | 0x36;
 UBRRL = 0xCF; //set baud rate lo
 UBRRH = 0x00; //set baud rate hi
 UCSRB = 0x08;
}

//call this routine to initialize all peripherals
void init_devices(void)
{
 //stop errant interrupts until set up
 CLI(); //disable all interrupts
 port_init();
 timer1_init();
 uart0_init();

 MCUCR = 0x00;
 GICR  = 0x00;
 TIMSK = 0x00; //timer interrupt sources
 SEI(); //re-enable interrupts
 //all peripherals are now initialized
}