netgen.xmsgs

来自「FPGA之间的LVDS传输」· XMSGS 代码 · 共 34 行

<?xml version="1.0" encoding="UTF-8"?>
<!-- IMPORTANT: This is an internal file that has been generated
     by the Xilinx ISE software.  Any direct editing or
     changes made to this file may result in unpredictable
     behavior or data corruption.  It is strongly advised that
     users do not edit the contents of this file. -->
<messages>
<msg type="warning" file="NetListWriters" num="306" delta="unknown" >Signal bus <arg fmt="%s" index="1">DATA_TO_OSERDES_REG</arg><arg fmt="%s" index="2">( 67 downto 0 )</arg> on block <arg fmt="%s" index="3">DDR_6TO1_16CHAN_RT_TX</arg> is not reconstructed, because there are some missing bus signals.
</msg>

<msg type="warning" file="NetListWriters" num="306" delta="unknown" >Signal bus <arg fmt="%s" index="1">Mcompar_check_data_error_cmp_ne0000_cy</arg><arg fmt="%s" index="2">( 19 downto 3 )</arg> on block <arg fmt="%s" index="3">synth_tb_lvds</arg> is not reconstructed, because there are some missing bus signals.
</msg>

<msg type="warning" file="NetListWriters" num="306" delta="unknown" >Signal bus <arg fmt="%s" index="1">Mcount_h_iram_addrb_cy</arg><arg fmt="%s" index="2">( 7 downto 3 )</arg> on block <arg fmt="%s" index="3">synth_tb_lvds</arg> is not reconstructed, because there are some missing bus signals.
</msg>

<msg type="warning" file="NetListWriters" num="306" delta="unknown" >Signal bus <arg fmt="%s" index="1">Mcount_blind_timer_cnt_cy</arg><arg fmt="%s" index="2">( 11 downto 3 )</arg> on block <arg fmt="%s" index="3">synth_tb_lvds</arg> is not reconstructed, because there are some missing bus signals.
</msg>

<msg type="info" file="NetListWriters" num="635" delta="unknown" >The generated VHDL netlist contains Xilinx <arg fmt="%s" index="1">SIMPRIM</arg> simulation primitives and has to be used with <arg fmt="%s" index="2">SIMPRIM</arg> library for correct compilation and simulation. 
</msg>

<msg type="info" file="NetListWriters" num="0" delta="unknown" >Setup Simulation - To perform a setup simulation, specify values in the Maximum (MAX) field with the following command line modifier:  -SDFMAX
</msg>

<msg type="info" file="NetListWriters" num="0" delta="unknown" >Hold Simulation - To perform the most accurate hold simulation, specify values in the Minimum (MIN) field with the following command line modifier:  -SDFMIN
</msg>

<msg type="info" file="NetListWriters" num="665" delta="unknown" >For more information on how to pass the SDF switches to the simulator, see your Simulator tool documentation.
</msg>

</messages>