ntt.me

speech signal process tools

.lo
.ce 2
.b
ESPS Binary and Source Kit Instructions (READ THIS FIRST)
.sp 1
Document Version: 1.2 6/16/89
.sh 1 "Introduction"
.pp
This ESPS kit contains both a full ESPS source tape and an ESPS binary
kit.   We have included the binary distribution to ensure that ESPS
programs are available in the event that there is some problem building from
source.  We do not anticipate such problems, but considering the
distance involved a backup seemed worthwhile.
.pp
You can start using ESPS immediately from this binary distribution, or
build a new one from the source tape.   If this binary is correctly
configured, then you might not want to bother with the source tape right
away.
.sh 1 "Configuration of the Binary Distribution"
.pp
This binary distribution is for a Masscomp 6000 series machine with an
EF-12 data acquisition board, and MC68881 floating point.   
For graphics support, this distribution
assumes Masscomp X Window graphics (X11). 
.sh 1 "Using this Distribution"
.pp
If you choose to use this binary distribution, follow the enclosed
instructions \fIInstallation Instructions for the ESPS Binary Release\fR.
.sh 1 "Using Source Distribution"
.pp
If you choose, instead, to build ESPS from the binary distribution, then
follow the enclosed instructions \fIInstallation Instructions for the
ESPS Source Release\fR.
.sh 1 "Loading Source after the Binary Distribution"
.pp
If you initially load the binary distribution, but later desire to load
the source also, the correct way to do that is to change directory to
\fI/usr/esps\fR and read the source tape in there.  This will create a
directory \fI/usr/esps/general\fR which contains the complete source tree.
.pp
Alternately, you can read in the source tape to any directory and then
put in a symbolic link from /usr/esps/general to that directory.  For
example, if you read the source tape into /usr/parker/esps_src, you
should make a link as follows:
.ft CW
.sp
% ln -s /usr/parker/esps_src/general /usr/esps/general
.ft R
.sh 1 "Changing Data Acquisition Parameters"
.pp
If your data acquisition does not match what is compiled in to the
binary distribution, you can fix just that by loading the source after
the binary and then editing the install script as described in the
source installation instructions to the set the parameters correctly for
your system.  Then simply give the command:
\fIinstall mcplay mcrecord\fR.
.pp
This will remake the play and record programs with the correct
parameters.