📄 bootseq.txt
字号:
(cpu/mpc7xxx/start.S)start: b boot_coldstart_warm: b boot_warmboot_cold:boot_warm: clear bats init l2 (if enabled) init altivec (if enabled) invalidate l2 (if enabled) setup bats (from defines in config_EVB) enable_addr_trans: (if MMU enabled) enable MSR_IR and MSR_DR jump to in_flashin_flash: enable l1 dcache gal_low_init: (board/evb64260/sdram_init.S) config SDRAM (CFG, TIMING, DECODE) init scratch regs (810 + 814) detect DIMM0 (bank 0 only) config SDRAM_PARA0 to 256/512Mbit bl sdram_op_mode detect bank0 width write scratch reg 810 config SDRAM_PARA0 with results config SDRAM_PARA1 with results detect DIMM1 (bank 2 only) config SDRAM_PARA2 to 256/512Mbit detect bank2 width write scratch reg 814 config SDRAM_PARA2 with results config SDRAM_PARA3 with results setup device bus timings/width setup boot device timings/width setup CPU_CONF (0x0) setup cpu master control register 0x160 setup PCI0 TIMEOUT setup PCI1 TIMEOUT setup PCI0 BAR setup PCI1 BAR setup MPP control 0-3 setup GPP level control setup Serial ports multiplex setup stack pointer (r1) setup GOT call cpu_init_f debug leds board_init_f: (common/board.c) board_early_init_f: remap gt regs? map PCI mem/io map device space clear out interupts init_timebase env_init serial_init console_init_f display_options initdram: (board/evb64260/evb64260.c) detect memory for each bank: dram_size() setup PCI slave memory mappings setup SCS setup monitor alloc board info struct init bd struct relocate_code: (cpu/mpc7xxx/start.S) copy,got,clearbss board_init_r(bd, dest_addr) (common/board.c) setup bd function pointers trap_init flash_init: (board/evb64260/flash.c) setup bd flash info cpu_init_r: (cpu/mpc7xxx/cpu_init.c) nothing mem_malloc_init malloc_bin_reloc spi_init (r or f)??? (CFG_ENV_IS_IN_EEPROM) env_relocated misc_init_r(bd): (board/evb64260/evb64260.c) mpsc_init2
⌨️ 快捷键说明
复制代码
Ctrl + C
搜索代码
Ctrl + F
全屏模式
F11
切换主题
Ctrl + Shift + D
显示快捷键
?
增大字号
Ctrl + =
减小字号
Ctrl + -