abstract.txt

nxp lpc177x/8x lcd keil&iar 例程

 /***********************************************************************
* $Id$		abstract.txt		2011-06-02		
* @file		LCD\Lcd_GFT035A320240Y\abstract.txt 
* @brief	Description of the LCD example.
* @version	1.0
* @date		02. June. 2011
* @author	NXP MCU SW Application Team
* 
* Copyright(C) 2011, NXP Semiconductor
* All rights reserved.
*
***********************************************************************
* Software that is described herein is for illustrative purposes only
* which provides customers with programming information regarding the
* products. This software is supplied "AS IS" without any warranties.
* NXP Semiconductors assumes no responsibility or liability for the
* use of the software, conveys no license or title under any patent,
* copyright, or mask work right to the product. NXP Semiconductors
* reserves the right to make changes in the software without
* notification. NXP Semiconductors also make no representation or
* warranty that such application will be suitable for the specified
* use without further testing or modification.
**********************************************************************/

@Example description:
	Purpose:
		  This example project describes how to test LCD module on LPC1788 IAR KickStart Rev.B board		  
	Process:	
		  The IAR, NXP and Onlimex logos appear on the LCD and the LCD hardware cursor moves as the 
		  board moves(the acceleration sensor is used).
		  It shows basic use of I/O, timer, interrupt and LCD controllers.
		  
		  This code is referenced from IAR source code.

@Directory contents:
	\EWARM: includes EWARM (IAR) project and configuration files
	\Keil:	includes RVMDK (Keil)project and configuration files	
	 
	\app: Include main file, logo & cursor image
	\board: board config file
	\modules: include supported drivers for this example 
	
@How to run:
	Hardware configuration:		
		This example was tested on:
			LPC1788 IAR Start Kit Rev.B
				- 3.3VA_E	:ON
				- VREG		:ON
				- IO_E		:ON
				- PWR_SEL	:depends on power source selection
		(Choose correct working board by setting "_CURR_USING_BRD" marco in .\BoardSupport\bsp.h file)
						
	
	Running mode:
		This example can run on ROM mode.
					
		Note: If want to burn hex file to board by using Flash Magic, these jumpers need
			to be connected:
			1. LPC1788 OEM Board rev A and OEM Base Board rev A
				- JP20: 1-2: ON
						3-4: ON
			(Using UART0 on USB serial port
			Sure that you choose correct COM port number - Pls reference at:
			"Device Manager" -> "Ports(COM & LPT)" -> "USB Serial Port (COMx)")
		    
		    2. LPC1788 IAR Start Kit Rev.B
				- RST_E: ON
				- ISP_E: ON
				
Step to run:
		- Step 1: Build example.
		- Step 2: Burn hex file into board (if run on ROM mode)
		- Step 3: Configure hardware and serial display as above instruction 
		- Step 4: Run example, observe LCD display
		
		@Warning: Maybe J-LINK power source cannot supply enough power for LCD