📄 act2000_isa.h
字号:
/* $Id: act2000_isa.h,v 1.4.6.1 2001/09/23 22:24:32 kai Exp $ * * ISDN lowlevel-module for the IBM ISDN-S0 Active 2000 (ISA-Version). * * Author Fritz Elfert * Copyright by Fritz Elfert <fritz@isdn4linux.de> * * This software may be used and distributed according to the terms * of the GNU General Public License, incorporated herein by reference. * * Thanks to Friedemann Baitinger and IBM Germany * */#ifndef act2000_isa_h#define act2000_isa_h#define ISA_POLL_LOOP 40 /* Try to read-write before give up */typedef enum { INT_NO_CHANGE = 0, /* Do not change the Mask */ INT_ON = 1, /* Set to Enable */ INT_OFF = 2, /* Set to Disable */} ISA_INT_T;/**************************************************************************//* Configuration Register COR (RW) *//**************************************************************************//* 7 | 6 | 5 | 4 | 3 | 2 | 1 | 0 *//* Soft Res| IRQM | IRQ Select | N/A | WAIT |Proc err *//**************************************************************************/#define ISA_COR 0 /* Offset for ISA config register */#define ISA_COR_PERR 0x01 /* Processor Error Enabled */#define ISA_COR_WS 0x02 /* Insert Wait State if 1 */#define ISA_COR_IRQOFF 0x38 /* No Interrupt */#define ISA_COR_IRQ07 0x30 /* IRQ 7 Enable */#define ISA_COR_IRQ05 0x28 /* IRQ 5 Enable */#define ISA_COR_IRQ03 0x20 /* IRQ 3 Enable */#define ISA_COR_IRQ10 0x18 /* IRQ 10 Enable */#define ISA_COR_IRQ11 0x10 /* IRQ 11 Enable */#define ISA_COR_IRQ12 0x08 /* IRQ 12 Enable */#define ISA_COR_IRQ15 0x00 /* IRQ 15 Enable */#define ISA_COR_IRQPULSE 0x40 /* 0 = Level 1 = Pulse Interrupt */#define ISA_COR_RESET 0x80 /* Soft Reset for Transputer *//**************************************************************************//* Interrupt Source Register ISR (RO) *//**************************************************************************//* 7 | 6 | 5 | 4 | 3 | 2 | 1 | 0 *//* N/A | N/A | N/A |Err sig |Ser ID |IN Intr |Out Intr| Error *//**************************************************************************/#define ISA_ISR 1 /* Offset for Interrupt Register */#define ISA_ISR_ERR 0x01 /* Error Interrupt */#define ISA_ISR_OUT 0x02 /* Output Interrupt */#define ISA_ISR_INP 0x04 /* Input Interrupt */#define ISA_ISR_SERIAL 0x08 /* Read out Serial ID after Reset */#define ISA_ISR_ERRSIG 0x10 /* Error Signal Input */#define ISA_ISR_ERR_MASK 0xfe /* Mask Error Interrupt */#define ISA_ISR_OUT_MASK 0xfd /* Mask Output Interrupt */#define ISA_ISR_INP_MASK 0xfb /* Mask Input Interrupt *//* Signature delivered after Reset at ISA_ISR_SERIAL (LSB first) */#define ISA_SER_ID 0x0201 /* ID for ISA Card *//**************************************************************************//* EEPROM Register EPR (RW) *//**************************************************************************//* 7 | 6 | 5 | 4 | 3 | 2 | 1 | 0 *//* N/A | N/A | N/A |ROM Hold| ROM CS |ROM CLK | ROM IN |ROM Out *//**************************************************************************/#define ISA_EPR 2 /* Offset for this Register */#define ISA_EPR_OUT 0x01 /* Rome Register Out (RO) */#define ISA_EPR_IN 0x02 /* Rom Register In (WR) */#define ISA_EPR_CLK 0x04 /* Rom Clock (WR) */#define ISA_EPR_CS 0x08 /* Rom Cip Select (WR) */#define ISA_EPR_HOLD 0x10 /* Rom Hold Signal (WR) *//**************************************************************************//* EEPROM enable Register EER (unused) *//**************************************************************************/#define ISA_EER 3 /* Offset for this Register *//**************************************************************************//* SLC Data Input SDI (RO) *//**************************************************************************/#define ISA_SDI 4 /* Offset for this Register *//**************************************************************************//* SLC Data Output SDO (WO) *//**************************************************************************/#define ISA_SDO 5 /* Offset for this Register *//**************************************************************************//* IMS C011 Mode 2 Input Status Register for INMOS CPU SIS (RW) *//**************************************************************************//* 7 | 6 | 5 | 4 | 3 | 2 | 1 | 0 *//* N/A | N/A | N/A | N/A | N/A | N/A |Int Ena |Data Pre *//**************************************************************************/#define ISA_SIS 6 /* Offset for this Register */#define ISA_SIS_READY 0x01 /* If 1 : data is available */#define ISA_SIS_INT 0x02 /* Enable Interrupt for READ *//**************************************************************************//* IMS C011 Mode 2 Output Status Register from INMOS CPU SOS (RW) *//**************************************************************************//* 7 | 6 | 5 | 4 | 3 | 2 | 1 | 0 *//* N/A | N/A | N/A | N/A | N/A | N/A |Int Ena |Out Rdy *//**************************************************************************/#define ISA_SOS 7 /* Offset for this Register */#define ISA_SOS_READY 0x01 /* If 1 : we can write Data */#define ISA_SOS_INT 0x02 /* Enable Interrupt for WRITE */#define ISA_REGION 8 /* Number of Registers *//* Macros for accessing ports */#define ISA_PORT_COR (card->port+ISA_COR)#define ISA_PORT_ISR (card->port+ISA_ISR)#define ISA_PORT_EPR (card->port+ISA_EPR)#define ISA_PORT_EER (card->port+ISA_EER)#define ISA_PORT_SDI (card->port+ISA_SDI)#define ISA_PORT_SDO (card->port+ISA_SDO)#define ISA_PORT_SIS (card->port+ISA_SIS)#define ISA_PORT_SOS (card->port+ISA_SOS)/* Prototypes */extern int act2000_isa_detect(unsigned short portbase);extern int act2000_isa_config_irq(act2000_card * card, short irq);extern int act2000_isa_config_port(act2000_card * card, unsigned short portbase);extern int act2000_isa_download(act2000_card * card, act2000_ddef __user * cb);extern void act2000_isa_release(act2000_card * card);extern void act2000_isa_receive(act2000_card *card);extern void act2000_isa_send(act2000_card *card);#endif /* act2000_isa_h */
⌨️ 快捷键说明
复制代码
Ctrl + C
搜索代码
Ctrl + F
全屏模式
F11
切换主题
Ctrl + Shift + D
显示快捷键
?
增大字号
Ctrl + =
减小字号
Ctrl + -