readme_wtbv3.txt

来自「基于matlab/simulink的风力发电建模系统」· 文本 代码 · 共 26 行

 #######################################################
 Installation Procedure for "Wind Turbine Blockset V3.0"
 #######################################################

 Version for Matlab 7.0.0 / (Service Pack 1) & Simulink 5.1

 Basically all the important models uses only Simulink blocks.
 However some models (measurement models) uses blocks from "DSP Blockset".

 Installation Procedure
 
 1. save the WTB_v3.change file to your hard-disk;
 2. change the extension from *.change to *.zip
 3. unzip this file
 4. copy the entire folder WTB_v3 somewhere on your hard-disk. 
	A good location is <matlab root>\toolbox\
 5. launch Matlab
 6. go to File-> SetPath..
 7. press "Add Folder with subfolders" button
 8. browse for the folder WTB_v3 and press "OK"
 9. press "Save" button and then close
10. open Simulink and the toolbox should appear somewhere at the bottom of the Simulink Toolboxes list

Note: Keep the Matlab path for this folder in top of the path list.