bdm_hcs08_erase_unsecure_hcs08.cmd

M68HC08及HCS08系列单片机bootloader引导程序源码/示例

// HCS08 erasing + unsecuring command file:
// These commands mass erase the chip then program the security byte to 0xFE (unsecured state + backdoor key mechanism enabled).

Memory < attributes ADDRESS 0 // do not display addresses below

FLASH MEMUNMAP // do not interact with regular flash programming monitor

wb 0x1802 0x03 // disable COP clearing SIMOPT register

wb 0x1825 0x30 // clear FPVIOL and FACCERR in FSTAT register
wb 0x1820 49   // set clock divider for 10 MHz bus speed with FECDIV register
               // Please see below to find how to evaluate this constant value.

wb 0x1824 0xFF // remove all flash protections clearing FPROT register
                      
//mass erase flash
wb 0x1825 0x30 // clear FPVIOL and FACCERR in FSTAT register
wb 0xc000 0    // (dummy) write to flash array to buffer address and data
wb 0x1826 0x41 // write MASS ERASE command in FCMD register
wb 0x1825 0x80 // set FCBEF in FSTAT register to execute the command 
wait 10

//blankcheck flash
wb 0x1825 0x30 // clear FPVIOL and FACCERR in FSTAT register
wb 0xc000 0    // (dummy) write to flash array to buffer address and data  
wb 0x1826 0x5  // write BLANK CHECK command in FCMD register 
wb 0x1825 0x80 // set FCBEF in FSTAT register to execute the command 
wait 10

//reprogram Security byte to Unsecure state
wb 0x1825 0x30 // clear FPVIOL and FACCERR in FSTAT register
wb 0xffbf 0xfe // write NVFEOPT register in flash array to UNSECURED state with Backdoor Key Mechanism enabled
wb 0x1826 0x20 // write BYTE PROGRAM command in FCMD register  
wb 0x1825 0x80 // set FCBEF in FSTAT register to execute the command 
wait 10

reset

wb 0x1802 0x03  // disable COP clearing SIMOPT register

FLASH MEMMAP // restore regular flash programming monitor


// Evaluate the clock divider to set in FECDIV register:

// An average programming clock of 175 kHz is chosen.

// If the bus frequency is less than 10 MHz, the value to store
// in FECDIV is equal to " bus frequency (kHz) / 175 ".

// If the bus frequency is higher than 10 MHz, the value to store
// in FECDIV is equal to " bus frequency (kHz) / 1400  + 0x40 (to set PRDIV8 flag)".

// Datasheet proposed values:
//
// bus frequency     FECDIV value (decimal)
// 
//  20 MHz            76
//  10 MHz            49
//   8 MHz            39
//   4 MHz            19
//   2 MHz             9
//   1 MHz             4
// 200 kHz             0
// 150 kHz             0