spi_master_no_ss.a51

Atmel (For 89C51, 89C52) 的 rs232 example

$INCLUDE   (reg_c51.INC)
transmit_completed BIT 20H.1; software flag
serial_data DATA 08H
data_save DATA 09H
data_example DATA 0AH;

org 000h
ljmp begin

org 4Bh
ljmp it_SPI

;/**
; * FUNCTION_PURPOSE: This file set up spi in master mode with 
; * Fclk Periph/128 as baud rate  and without slave select pin
; * FUNCTION_INPUTS: P1.5(MISO) serial input  
; * FUNCTION_OUTPUTS: P1.7(MOSI) serial output
; *                   P1.1
; */
org 0100h
begin:

;init
MOV data_example,#55h;           /* data example */

ORL SPCON,#10h;                  /* Master mode */
ORL SPCON,#20h;                  /* P1.1 is available as standard I/O pin */
ORL SPCON,#82h;                  /* Fclk Periph/128 */
ANL SPCON,#0F7h;                 /* CPOL=0; transmit mode example */
ORL SPCON,#04h;                  /* CPHA=1; transmit mode example */
ORL IEN1,#04h;                   /* enable spi interrupt */
ORL SPCON,#40h;                  /* run spi */
CLR transmit_completed;          /* clear software transfert flag */
SETB EA;                         /* enable interrupts */

loop:                            /* endless */

   CPL P1.1;                     /* P1.1 is available as standard I/O pin */ 
   MOV SPDAT,data_example;       /* send an example data */
   JNB transmit_completed,$;     /* wait end of transmition */
   CLR transmit_completed;       /* clear software transfert flag */

   MOV SPDAT,#00h;               /* data is send to generate SCK signal */
   JNB transmit_completed,$;     /* wait end of transmition */
   CLR transmit_completed;       /* clear software transfert flag */
   MOV data_save,serial_data;    /* save receive data */  

LJMP loop


;/**
; * FUNCTION_PURPOSE:interrupt
; * FUNCTION_INPUTS: void
; * FUNCTION_OUTPUTS: transmit_complete is software transfert flag
; */
it_SPI:;                         /* interrupt address is 0x004B */

MOV R7,SPSTA;
MOV ACC,R7
JNB ACC.7,break1;case 0x80:
    MOV serial_data,SPDAT;       /* read receive data */
    SETB transmit_completed;     /* set software flag */
break1:

JNB ACC.4,break2;case 0x10:
;         /* put here for mode fault tasking */	
break2:;
	
JNB ACC.6,break3;case 0x40:
;         /* put here for overrun tasking */	
break3:;

RETI

end