abstract.txt

keilc pic的版本 才搞到的 希望对大家有帮助

Monitor for Phytec nM164 1MB 

You need under Options - L166 Misc RESERVE:
  8H-0BH, 0ACH-0AFH

For correct using the Monitor with a Phytec 
developent board:
connect the PC COM port to P1 connector

Jumper Settings of the development board:

XX = jumper     O = free pin

O X X O O X X O 
O O O X X X X O 
JP2                                                        

JP1 closed between 2+3

Simultaneously press the Reset (S1) and Boot (S2) switches on the
Development Board, first releasing the Reset (S1) and then, two or
three seconds later, release the Boot (S2) switch.
This sequence of pressing and releasing the Reset (S1) and Boot (S2)
switches renders the nanoMODUL-164 into the Bootstrap mode.


BOOTSTRAP MODE
==============

Memory map for modules with
256kB Flash and 256kB SRAM or
512kB Flash and 512kB SRAM (MODE0):

 00:0000h - 00:F9FFh  Flash
 00:FA00h - 00:FFFFh  internal RAM and SFR's
 01:0000h - 03:FFFFh  free RAM
 04:0000h - 07:E8FFh  free RAM (mirrored by 256kB)
 07:E900h - 07:EAFFh  RAM used by MONITOR
 07:EB00h - 07:FFFFh  RAM used by MONITOR (Code Area)
 08:0000h - 0B:FFFFh  Flash ROM
 0C:0000h - 0F:7FFFh  Flash ROM (mirrored by 256KB)
 0F:8000h - 0F:9FFFh  I/O1 
 0F:A000h - 0F:BFFFh  I/O2
 0F:C000h - 0F:DFFFh  I/O3
 0F:E000h - 0F:FFFFh  I/O4



Memory map for modules with
1MB Flash and 512kB SRAM (MODE0):

 0F:E900h - 0F:EAFFh  RAM used by MONITOR
 0F:EB00h - 0F:FFFFh  RAM used by MONITOR (Code Area)