abstract.txt

keilc pic的版本 才搞到的 希望对大家有帮助

Monitor for Phytec KC161 Board 

You need under Options - L166 Misc RESERVE:
  8H-0BH, 0ACH-0AFH

For correct using the Monitor:
  connect the PC COM port to P1 connector


BOOTSTRAP MODE
==============

Jumper Settings:
 JP9: 1+2 (Bootstrap Mode enabled)  
 JP4: closed (Mode 0)  

Memory map (Mode 0):
 00:0000h - 01:0000h RAM
 0F:EA00h - 0F:EBFFh RAM used by Monitor (Data Area)
 0F:EC00h - 0F:FFFFh RAM used by Monitor (Code Area)
 10:0000h - 1F:7FFFh Flash
 01:F800h - 1F:FFFFh Flash (32KB Bootblock)
 20:0000h - 2F:FFFFh I/O area #1
 30:0000h - 3F:DFFFh I/O area #2


NON-BOOTSTRAP MODES:
====================

You will find two ready Monitor programs in this directory:
 - MONITOR.H86 for Target "UART ASC0" and Automatic baudrate detection
 - MONSIM.H86 for Target "Simulated Serial"
 
Jumper Settings for On-Board FLASH programming:
 * JP9: 1+2 (Bootstrap Mode enabled)
 * JP4: open (Mode 1) 
 Load the MONITOR.H86 into the Flash-ROM using the 
 Phytec FLASHT.EXE programming tool.
  
Jumper Settings for NON-BOOTSTRAP Modes:
 JP9: 2+3 (Bootstrap Mode disabled)
 JP4: open (Mode 1) 
 
Memory map after boot process (Mode 1):
 00:0000h - 03:7FFFh Flash conataining Monitor-Code
 00:3800h - 03:FFFFh Flash (32KB Bootblock in Standard Configuration)
 0F:8000h - 0F:FFFFh Flash (32KB Bootblock at Maximum Memory 1MB SRAM)
 04:0000h - 0F:FFFFh Flash (optional)
 10:0000h - 10:FFFFh RAM
 11:0000h - 1F:0000h RAM (optional)
 20:0000h - 2F:FFFFh I/O area #1
 30:0000h - 3F:DFFFh I/O area #2

Jumper Settings for SIMULATED SERIAL Debug interface:
 JP11:  (closed) P2.9 as RS232 Debug-Interface
 Load the MONSIM.H86 into the Flash-ROM using the 
 Phytec FLASHT.EXE programming tool.