hplcc2420interrupt.nc

来自「tinyos最新版」· NC 代码 · 共 61 行

// $Id: HPLCC2420Interrupt.nc,v 1.1 2004/09/19 23:44:27 jpolastre Exp $

/*									tab:4
 * "Copyright (c) 2000-2003 The Regents of the University  of California.  
 * All rights reserved.
 *
 * Permission to use, copy, modify, and distribute this software and its
 * documentation for any purpose, without fee, and without written agreement is
 * hereby granted, provided that the above copyright notice, the following
 * two paragraphs and the author appear in all copies of this software.
 * 
 * IN NO EVENT SHALL THE UNIVERSITY OF CALIFORNIA BE LIABLE TO ANY PARTY FOR
 * DIRECT, INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES ARISING OUT
 * OF THE USE OF THIS SOFTWARE AND ITS DOCUMENTATION, EVEN IF THE UNIVERSITY OF
 * CALIFORNIA HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
 * 
 * THE UNIVERSITY OF CALIFORNIA SPECIFICALLY DISCLAIMS ANY WARRANTIES,
 * INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY
 * AND FITNESS FOR A PARTICULAR PURPOSE.  THE SOFTWARE PROVIDED HEREUNDER IS
 * ON AN "AS IS" BASIS, AND THE UNIVERSITY OF CALIFORNIA HAS NO OBLIGATION TO
 * PROVIDE MAINTENANCE, SUPPORT, UPDATES, ENHANCEMENTS, OR MODIFICATIONS."
 *
 */
/*
 * Authors:		Joe Polastre
 */

/**
 * @author Joe Polastre
 */


interface HPLCC2420Interrupt {

  /** 
   * Enable an edge based interrupt
   *
   * @param low_to_high TRUE if the edge interrupt should occur on
   *        a low to high transition, FALSE for high to low.
   *
   * @return SUCCESS if the interrupt has been enabled
   */
  async command result_t startWait(bool low_to_high);

  /**
   * Fired when an edge interrupt occurs.
   *
   * @return SUCCESS to keep the interrupt enabled (equivalent to
   *         calling startWait again), FAIL to disable the interrupt
   */
  async event result_t fired();


  /**
   * Diables an edge interrupt or capture interrupt
   * 
   * @return SUCCESS if the interrupt has been disabled
   */ 
  async command result_t disable();
}