aboot.sgml

abootLoader 固件源代码 HP内部珍贵资料！

<!DOCTYPE RefEntry PUBLIC "-//OASIS//DTD DocBook V4.1//EN">
<refentry id="aboot">

<refmeta>
<refentrytitle>aboot</refentrytitle>
<manvolnum>8</manvolnum>
<refmiscinfo>aboot</refmiscinfo>
</refmeta>

<refnamediv>
<refname>aboot</refname>
<refpurpose>The secondary boot loader for Linux/Alpha</refpurpose>
</refnamediv>

<refsect1><title>COPYRIGHT</title>
<para>
<application>aboot</application> is Copyright (C) 1996 Linus Torvalds, David Mosberger and Michael Schwingen (??)
</para>
</refsect1>

<refsect1><title>DESCRIPTION</title>
<para>
<indexterm><primary>aboot</primary></indexterm>
<application>aboot</application> is the secondary boot loader needed if
the Linux/Alpha system is booted via SRM. It is usually installed during
system installation by <application>swriteboot</application>(8). 
</para>
<para>
To automate the booting process predefined boot configurations can be stored
in <filename>etc/aboot.conf</filename>(5). 
</para>
<para>
<application>aboot</application> can also be used interactively by issuing
</para>
<para>
<command>boot <parameter>dka0 -fl "i"</parameter></command>
</para>
<para>
at the SRM-Prompt where dka0 has to be replaced by the device used. 
</para>
<para>
In the interactive mode you can use the command h to show your current
<filename>etc/aboot.conf</filename> and then the appropriate number
(or a complete boot command as in SRM) to boot Linux.
</para>
<para>
If you do not want to use the <filename>etc/aboot.conf</filename> as set
up by <application>abootconf</application> you can explicitly tell 
<application>aboot</application> where to look for <filename>etc/aboot.conf</filename> by prepending the number of the configuration with the proper
partition, i.e. if your <filename>etc/aboot.conf</filename> is on your
second partition and you want to boot the entry labled three you would
issue
</para>
<para>
<command>boot <parameter>dqa -fl "2:3"</parameter></command>
</para>
<para>
Note that this applies to Linux booting via SRM only as
<ProductName>VMS</ProductName>, <ProductName>Tru64</ProductName>, *BSD and
<ProductName>Windows NT</ProductName> each have their own secondary boot loader.
Furthermore <application>aboot</application> is also not needed if the system is booted via
<application>milo</application>.
</para>
</refsect1>


<refsect1><title>AUTHOR</title>
<para>
This man page was written by Helge Kreutzmann
<email>[e-mail]</email> for the Debian GNU/Linux project.
</para>
</refsect1>

<refsect1><title>FILES</title>
<para><filename>etc/aboot.conf</filename></para>
</refsect1>

<refsect1><title>SEE ALSO</title>
<para><application>abootconf</application>(8), <filename>aboot.conf</filename>(5),
<application>swriteboot</application>(8), Compaq SRM Manual</para>
</refsect1>
</refentry>