etc.c

这是三星公司的arm7 s3c44b0x芯片的所有外设中断程序

//44BTEST : etc.c
#include <string.h>
#include "..\inc\44b.h"
#include "..\inc\44blib.h"
#include "..\inc\etc.h"
#include "..\inc\def.h"
/*
void Test_WaitPin(void)
{
U32 readVal;
Uart_Printf("nGCS1 is controlled by nWAIT pin.\n");
Uart_Printf("nWAIT/PF0 pin is configured as nWAIT pin.\n");
Uart_Printf("\nPush any key to exit!!!\n");
// Work-around with nWAIT.
// 8bit device ->8bit bus width, 16bit access
// address0 is not connected to the device to cheat the device.
rBWSCON=rBWSCON & ~(0x7<<4)|(0x5<<4); //nGCS1: nWAIT enable, 8bit
rBANKCON1=0x200;
rNCACHBE0=( (0x4000000>>12)<<16 )|(0x2000000>>12);
while(Uart_GetKey()==0x0)
{
readVal=(*(volatile U16 *)0x2000000);
#ifdef __BIG_ENDIAN
readVal=readVal&0xff;
#else
readVal=readVal>>8;
#endif
Uart_Printf("read_data=%x\n",readVal);
}
}
*/
extern char Image$$RO$$Limit[];
extern char Image$$RO$$Base[];
extern char Image$$RW$$Limit[];
extern char Image$$RW$$Base[];
extern char Image$$ZI$$Limit[];
extern char Image$$ZI$$Base[];
void Etc(void)
{
Uart_Printf("Image$$RO$$Base=%x\n",Image$$RO$$Base);
Uart_Printf("Image$$RO$$Limit=%x\n",Image$$RO$$Limit);
Uart_Printf("Image$$RW$$Base=%x\n",Image$$RW$$Base);
Uart_Printf("Image$$RW$$Limit=%x\n",Image$$RW$$Limit);
Uart_Printf("Image$$ZI$$Base=%x\n",Image$$ZI$$Base);
Uart_Printf("Image$$ZI$$Limit=%x\n",Image$$ZI$$Limit);
}