config.in

这个linux源代码是很全面的~基本完整了~使用c编译的~由于时间问题我没有亲自测试~但就算用来做参考资料也是非常好的

if [ "$CONFIG_SCSI_AIC7XXX_OLD" != "y" ]; then
   dep_tristate 'Adaptec AIC7xxx support' CONFIG_SCSI_AIC7XXX $CONFIG_SCSI
   if [ "$CONFIG_SCSI_AIC7XXX" != "n" ]; then
      int  '  Maximum number of TCQ commands per device' \
	CONFIG_AIC7XXX_CMDS_PER_DEVICE 253
      int  '  Initial bus reset delay in milli-seconds' \
	CONFIG_AIC7XXX_RESET_DELAY_MS 15000
      bool  '  Probe for EISA and VL AIC7XXX Adapters' \
	CONFIG_AIC7XXX_PROBE_EISA_VL
      bool  '  Build Adapter Firmware with Kernel Build' \
	CONFIG_AIC7XXX_BUILD_FIRMWARE
   fi
fi
dep_tristate 'Adaptec AIC79xx support' CONFIG_SCSI_AIC79XX $CONFIG_SCSI
if [ "$CONFIG_SCSI_AIC79XX" != "n" ]; then
   int  '  Maximum number of TCQ commands per device' \
	CONFIG_AIC79XX_CMDS_PER_DEVICE 253
   int  '  Initial bus reset delay in milli-seconds' \
	CONFIG_AIC79XX_RESET_DELAY_MS 15000
   bool  '  Build Adapter Firmware with Kernel Build' \
	CONFIG_AIC79XX_BUILD_FIRMWARE
   bool  '  Enable Read Streaming for All Targets' \
	CONFIG_AIC79XX_ENABLE_RD_STRM
   bool  '  Compile in Debugging Code' \
	CONFIG_AIC79XX_DEBUG_ENABLE
   int  '  Debug code enable mask (16384 for all debugging)' \
	CONFIG_AIC79XX_DEBUG_MASK 0
fi