readme

VXWorks for ARM 的 BSP模板

      README: Wind River SBC ARM7 BSP for Samsung's KS32C50100

This file contains board-specific information for the SBC ARM7 target
board.  This file documents BSP interface changes from previous
software or hardware versions, and notifies the user of serious
caveats that must be noted before using this BSP.  Additionally, the
target board's reference entry (i.e. wrSbcArm7/target.nr) provides
board-specific information necessary to run VxWorks and should be read
fully before this BSP is used.

--------------------------------------------------------------------------------
RELEASE 1.2/18
         Better handling of auto-negotiation of the PHY

RELEASE 1.2/17
        Tornado 2.2 support
        Fix END rx error handling
        Fix END polled mode
        Fix non-default clock rate serial problems

RELEASE 1.2/16
        ROM resident support

RELEASE 1.2/15
        Big Endian support
        Thumb support
        Big Endian/Thumb support
        Ethernet MAC address based on DIP settings
        END driver registers now written using volatile
        sysClkRateSet() now changes the clock rate

RELEASE 1.2/14
        Minor changes to the default boot line

RELEASE 1.2/13
        Minor changes to support UNIX builds

RELEASE 1.2/12
        Enable cache support.
        Add support for launching the VxWorks image using visionWARE 2.00.

RELEASE 1.2/11
        Fixed Ethernet FIFO overflow problems.
        Fixed crashing sysClkConnect.

RELEASE 1.2/10
        Added support for NVRAM.
        Fixed issues with timestamp.
        Cleaned up the documentation.

RELEASE 1.2/9
        First beta release (for Tornado 2.0).