ieee154send.nc

tinyos-2.x.rar

/*
 * "Copyright (c) 2008 The Regents of the University  of California.
 * All rights reserved."
 *
 * Permission to use, copy, modify, and distribute this software and its
 * documentation for any purpose, without fee, and without written agreement is
 * hereby granted, provided that the above copyright notice, the following
 * two paragraphs and the author appear in all copies of this software.
 *
 * IN NO EVENT SHALL THE UNIVERSITY OF CALIFORNIA BE LIABLE TO ANY PARTY FOR
 * DIRECT, INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES ARISING OUT
 * OF THE USE OF THIS SOFTWARE AND ITS DOCUMENTATION, EVEN IF THE UNIVERSITY OF
 * CALIFORNIA HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
 *
 * THE UNIVERSITY OF CALIFORNIA SPECIFICALLY DISCLAIMS ANY WARRANTIES,
 * INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY
 * AND FITNESS FOR A PARTICULAR PURPOSE.  THE SOFTWARE PROVIDED HEREUNDER IS
 * ON AN "AS IS" BASIS, AND THE UNIVERSITY OF CALIFORNIA HAS NO OBLIGATION TO
 * PROVIDE MAINTENANCE, SUPPORT, UPDATES, ENHANCEMENTS, OR MODIFICATIONS."
 *
 */

#include <TinyError.h>
#include <message.h>
#include <Ieee154.h>

/*
 *
 * The only change from the AMSend interface is that instead of
 * sending to an AMID, we now send to a ieee154_saddr_t.
 *
 */

interface Ieee154Send {

  /** 
    * Send a packet with a data payload of <tt>len</tt> to address
    * <tt>addr</tt>. To determine the maximum available size, use the
    * Packet interface of the component providing AMSend. If send
    * returns SUCCESS, then the component will signal the sendDone
    * event in the future; if send returns an error, it will not
    * signal the event.  Note that a component may accept a send
    * request which it later finds it cannot satisfy; in this case, it
    * will signal sendDone with error code.
    *
    * @param addr   address to which to send the packet
    * @param msg    the packet
    * @param len    the length of the data in the packet payload
    * @return       SUCCESS if the request to send succeeded and a
    *               sendDone will be signaled later, EBUSY if the
    *               abstraction cannot send now but will be able to
    *               later, or FAIL if the communication layer is not
    *               in a state that can send (e.g., off).
    * @see          sendDone
    */ 
  command error_t send(ieee154_saddr_t addr, message_t* msg, uint8_t len);

  /**
    * Cancel a requested transmission. Returns SUCCESS if the 
    * transmission was canceled properly (not sent in its
    * entirety). Note that the component may not know
    * if the send was successfully canceled, if the radio is
    * handling much of the logic; in this case, a component
    * should be conservative and return an appropriate error code.
    * A successful call to cancel must always result in a 
    * sendFailed event, and never a sendSucceeded event.
    * 
    * @param  msg     the packet whose transmission should be cancelled.
    * @return SUCCESS if the transmission was cancelled, FAIL otherwise.
    * @see    sendDone
    */
  command error_t cancel(message_t* msg);

  /** 
    * Signaled in response to an accepted send request. <tt>msg</tt> is
    * the message buffer sent, and <tt>error</tt> indicates whether
    * the send was successful.
    *
    * @param  msg   the packet which was submitted as a send request
    * @param  error SUCCESS if it was sent successfully, FAIL if it was not,
    *               ECANCEL if it was cancelled
    * @see send
    * @see cancel
    */ 

  event void sendDone(message_t* msg, error_t error);


   /**
   * Return the maximum payload length that this communication layer
   * can provide. This command behaves identically to
   * <tt>Packet.maxPayloadLength</tt> and is included in this
   * interface as a convenience.
   *
   * @return the maximum payload length
   */

  
  command uint8_t maxPayloadLength();


   /**
    * Return a pointer to a protocol's payload region in a packet.
    * This command behaves identically to <tt>Packet.getPayload</tt>
    * (minus the length parameter) and is included in this interface
    * as a convenience.
    *
    * @param  msg    the packet
    * @return        the payload of the packet
    */
  command void* getPayload(message_t* msg, uint8_t len);

  
}