md142am.h

64输入32输出单片机程序

//-------------------------------------------------------------------------
//	Filename :  Md142AM.h
//	Language :  C for AT89S8252
//	    Date :  13/08/2002
//   Description :  Header file for Md134AM.C
//-------------------------------------------------------------------------
#ifdef _MD142AM_H_
   #define EXTERNAL
#else
   #define EXTERNAL  extern
#endif
//-------------------------------------------------------------------------
// define varible length constant
#define SIZE	  5
#define LWORD	  4
#define LBYTE	  2
//-------------------------------------------------------------------------
//-------------------------------------------------------------------------
typedef struct{
    unsigned char  row;
    unsigned char  col;
    unsigned char  size;
    void * pData;
} SET_INF;
//-------------------------------------------------------------------------

//-------------------------------------------------------------------------
//  Character constant define

char code *Initcomm	 = "  Initial serial communication......    ";
char code *Commfail	 = "   Communication connect fail !!!!      ";
char code *Checkserial	 = "   Please Check connect wire !!!!       ";
char code *Ontext	 = " ON           ";
char code *Offtext	 = "OFF           ";
char code *Invalid	 = "Invalid number";
char code *Troublemsge	 = "    Heater or coolant not ready!!!!     "
			   "    Check the inductors or pumps!!      "
			   "  Be sure OK then press F1 to go on !!  "
			   "[G0 ON]                                 ";

char code *Projectname	 = "   Johnson Electric Industry CO.,LTD    "
			   "        ARMATURE EPOXY COATING          "
			   "                                        "
			   " [Auto]   [Manual]   [Setup]   [Exit]  ";


char code *Manualmap	 = "          MANUAL OPERATION              "
			   "  Cylinder:                             "
			   "                                        "
			   "[ON/OFF] [Manudata1] [Manudata2]  [Exit] ";
char code *Automap	 = "          AUTOMATIC OPERATION           "
			   "    Heat1_time:      Heat2_time:        "
			   "    Spray_time:       Blow_time:        "
			   "[Start]   [Pause]    [Manual]     [Exit] ";

char code *Setupmap	 = "    Heat1_time:       Blow_time:        "
			   "    Heat2_time:                         "
			   "    Spray_time:       Max value:25.5sec "
			   "[Enter]   <= / =>                 [Exit] ";


char code *Manualdata1	 = "LOAD_VERT  1 LOAD_HORN   2 INDUCTION1 3 "
			   "ARM1       4  ARM2        5 ARM3       6"
			   "AIR_MAGNET1 7 AIR_MAGNET2 8 AIR_CHUCK  9"
			   "TRAN_HORN  10 SHAFT_HOLD 11 SPRAY_L   12";


char code *Manualdata2	 = "SPRAY_R  13  JIG_EJECT  14 JIG_REMOVE 15"
			   "COMM_LOAD   16 COMM_INSERT  17 ALARM  20"
			   "INDUCTION2  18 UNLOAD       19 VIB.   30"
			   "MAGNEFORCE1 35 MAGNEFORCE2  36 ROTATE 31";


//-------------------------------------------------------------------------