📄 rfc1520.txt
字号:
Network Working Group Y. Rekhter
Request for Comments: 1520 T.J. Watson Research Center, IBM Corp.
Category: Informational C. Topolcic
CNRI
September 1993
Exchanging Routing Information Across Provider Boundaries
in the CIDR Environment
Status of this Memo
This memo provides information for the Internet community. It does
not specify an Internet standard. Distribution of this memo is
unlimited.
1. Introduction
Classless Inter-Domain Routing (CIDR) has been adopted as a solution
to the scaling problem in the Internet. The overall CIDR architecture
is described in [1]. The architecture for IP address assignment with
CIDR is covered in [2] and [3]. The inter-domain routing protocols
that are capable of supporting CIDR are covered in [4], [5], and [6].
The purpose of this document is twofold. First, it describes various
alternatives for exchanging inter-domain routing information across
domain boundaries, where one of the peering domain is CIDR-capable
and another is not. Second, it addresses the implications of running
CIDR-capable inter-domain routing protocols (e.g., BGP-4, IDRP) on
intra-domain routing.
This document is not intended to cover all the cases (either real or
imaginable). Rather, it focuses on what are viewed to be the most
common cases. We expect that individual service providers will use
this document as guidelines in establishing their specific
operational plans for the transition to CIDR.
The concepts of "network service provider" and "network service
subscriber" were introduced in [3]. For the sake of brevity, we will
use the term "provider" or "service provider" here to mean either
"network service provider" or "network service subscriber", since for
the most part, the distinction is not important to this discussion.
Furthermore, we use the same terms to refer to the network and to the
organization that operates the network. We feel that the context
makes it amply clear whether we are talking about hardware or people,
and defining different terms would only make this paper harder to
read.
Rekhter & Topolcic [Page 1]
RFC 1520 CIDR Provider Information Exchange September 1993
This document defines a CIDR-capable provider as the provider that
can perform correct IP packet forwarding (both internally and to
other adjacent providers) when the inter-domain routing information
acquired by the provider is expressed solely in terms of IP address
prefixes (with no distinction between A/B/C class of addresses).
This document defines CIDR-capable forwarding as the ability of a
router to maintain its forwarding table and to perform correct
forwarding of IP packets without making any assumptions about the
class of IP addresses.
This document defines CIDR reachability information as reachability
information that may violate any assumptions about the class of IP
addresses. For instance, a contiguous block of class C networks
expressed as a single IP address prefix constitutes CIDR reachability
information.
2. Taxonomy of Service Providers
For the purpose of this document we partition all service providers
into the following categories, based on the type and volume of
inter-domain routing information a provider needs to acquire in order
to meet its service requirements:
- Requirements imposed on a service provider preclude it from
using Default inter-domain route(s) -- we'll refer to such a
pqrovider as a Type 1 provider.
- Requirements imposed on a service provider allow it to rely on
using one or more Default routes for inter-domain routing, but
this information must be supplemented by requiring the provider
to acquire a large percentage of total Internet routing
information -- we'll refer to such a provider as a Type 2
provider.
- Requirements imposed on a service provider allow it to rely on
using one or more Default routes for inter-domain routing;
however, to meet its service requirements the provider must
supplement Default route(s) by acquiring a small percentage of
total Internet routing information -- we'll refer to such a
provider as a Type 3 provider.
- Requirements imposed on a service provider allow it to rely
solely on using one or more Default routes for inter-domain
routing; no other inter-domain routing information need to be
acquired -- we'll refer to such a provider as a Type 4 provider.
Rekhter & Topolcic [Page 2]
RFC 1520 CIDR Provider Information Exchange September 1993
3. Assumptions on Deployment of CIDR in the Internet
The document assumes that the CIDR deployment in the Internet will
proceed as a three phase process.
In the first phase all the major service providers will become CIDR-
capable. Specifically, all the providers that can't rely on using
Default route(s) for inter-domain routing (Type 1 providers) are
expected to deploy BGP-4 and transition to CIDR during this phase. It
is expected that CIDR reachability information will first appear in
the Internet upon transition of all Type 1 service providers to CIDR.
The second phase will commence upon completion of the first phase.
During the second phase other service providers that are connected to
the service providers that were transitioned to CIDR during the first
phase will become CIDR-capable. Specifically, during the second
phase it is expected that most of the providers that need to acquire
a large percentage of the total Internet routing information (Type 2
provider) will become CIDR-capable. In addition, during the second
phase some of the Type 3 providers may become CIDR-capable as well.
This plan was agreed to by a number of major providers [8]. NSFNET's
steps to implement this plan are described in [9].
Finally, during the third phase the rest of the Type 3 providers and
most of the Type 4 providers will transition to CIDR.
It is expected that the duration of the first phase will be
significantly shorter than duration of the second phase. Likewise,
the duration of the second phase is expected to be shorter than the
duration of the third phase.
This document addresses the need for service providers to exchange
inter-domain routing information during the second and third phases
of this deployment. During these phases, some providers will be
CIDR-capable, and others will not. Hence this document considers
routing exchanges where one of the peers is CIDR-capable and the
other is CIDR-incapable.
4. Implications of CIDR on Interior Routing
A CIDR-capable service provider can use the following two techniques
to distribute exterior routing information to all of its routers
(both interior and border):
- utilize internal BGP/IDRP between all the routers
- use CIDR-capable IGPs (e.g., OSPF, IS-IS, RIP2)
Rekhter & Topolcic [Page 3]
RFC 1520 CIDR Provider Information Exchange September 1993
The first technique doesn't impose any addition requirements on the
IGP within the provider. Additional information on implementing the
first option is presented in [5] (see Section A.2.4).
The second technique allows the provider to reduce the utilization of
internal BGP/IDRP, but imposes specific requirements on the intra-
domain routing. It also requires the ability to inject inter-domain
routing information (acquired either via BGP or IDRP) into the
intra-domain routing. Additional details on implementing the second
option are provided in [7]. It is not expected that all the features
enumerated in [7] will be widely needed. Therefore, it would be
highly desirable to prioritize the features.
Note that both of these techniques imply that all the routers within
a CIDR-capable service provider need to be capable of CIDR-based
forwarding.
Discussion of which of the two techniques should be preferred is
outside the scope of this document.
5. Exchanging Inter-Domain Routing Information
At each phase during the transition to CIDR one of the essential
aspects of the Internet operations will be the exchange of inter-
domain routing information between CIDR-capable providers and CIDR-
incapable provider.
When exchanging inter-domain routing information between a CIDR-
capable provider and a CIDR-incapable provider, it is of utmost
importance to take into account the view each side wants the other to
present. This view has two distinct aspects:
- the type of routing information exchanged (i.e., Default route,
traditional (non-CIDR) reachability information, CIDR
reachability information)
- routing information processing each side needs to do to maintain
these views (e.g., ability to perform aggregation, ability to
perform controlled de-aggregation)
The exchange of inter-domain routing information is expected to be
controlled by bilateral agreements between the directly connected
service providers. Consequently, the views each side wants of the
other are expected to form an essential component of such agreements.
To facilitate troubleshooting and problem isolation, the bilateral
agreements should be made accessible to other providers. One way to
accomplish this is by placing them in a generally accessible
Rekhter & Topolcic [Page 4]
RFC 1520 CIDR Provider Information Exchange September 1993
database. The details of how this can be implemented are outside the
scope of this document. A possible way to accomplish this is
described in [9].
Since the exchange of inter-domain routing information across
provider boundaries occurs on a per peer basis, a border router is
expected to provide necessary mechanisms (e.g., configuration) that
will control exchange and processing of this information on a per
peer basis.
In the following sections we describe possible scenarios for
exchanging inter-domain routing information. It is always assumed
that one side is CIDR-capable and the other is not.
5.1 Exchanging Inter-Domain Routing Information between CIDR-capable
providers and CIDR-incapable Type 2 (default with large proportion
of explicit routes) providers
We expect the border router(s) within a CIDR-capable provider to be
capable of aggregating inter-domain routing information they receive
from a CIDR-incapable Type 2 provider. The aggregation is expected
to be governed and controlled via a bilateral agreement.
Specifically, the CIDR capable provider is expected to aggregate only
the information the other side (the CIDR-incapable provider)
⌨️ 快捷键说明
复制代码
Ctrl + C
搜索代码
Ctrl + F
全屏模式
F11
切换主题
Ctrl + Shift + D
显示快捷键
?
增大字号
Ctrl + =
减小字号
Ctrl + -