📄 if_css.c
字号:
#ifndef lintstatic char *sccsid = "@(#)if_css.c 4.1 ULTRIX 11/23/87";#endif lint/************************************************************************ * * * Copyright (c) 1985 by * * Digital Equipment Corporation, Maynard, MA * * All rights reserved. * * * * This software is furnished under a license and may be used and * * copied only in accordance with the terms of such license and * * with the inclusion of the above copyright notice. This * * software or any other copies thereof may not be provided or * * otherwise made available to any other person. No title to and * * ownership of the software is hereby transferred. * * * * This software is derived from software received from the * * University of California, Berkeley, and from Bell * * Laboratories. Use, duplication, or disclosure is subject to * * restrictions under license agreements with University of * * California and with AT&T. * * * * The information in this software is subject to change without * * notice and should not be construed as a commitment by Digital * * Equipment Corporation. * * * * Digital assumes no responsibility for the use or reliability * * of its software on equipment which is not supplied by Digital. * * * ************************************************************************/#include "css.h"#if NCSS > 0 || defined(BINARY)/* * DEC/CSS IMP11-A ARPAnet IMP interface driver. * Since "imp11a" is such a mouthful, it is called * "css" after the LH/DH being called "acc". * * Configuration notes: * * As delivered from DEC/CSS, it * is addressed and vectored as two DR11-B's. This makes * Autoconfig almost IMPOSSIBLE. To make it work, the * interrupt vectors must be restrapped to make the vectors * consecutive. The 020 hole between the CSR addresses is * tolerated, althought that could be cleaned-up also. * * Additionally, the TRANSMIT side of the IMP11-A has the * lower address of the two subunits, so the vector ordering * in the CONFIG file is reversed from most other devices. * It should be: * * device css0 .... cssxint cssrint * * If you get it wrong, it will still autoconfig, but will just * sit there with RECIEVE IDLE indicated on the front panel. * * if_css.c 7.1 (Berkeley) 6/5/86 * * 13-Jun-86 -- jaw fix to uba reset and drivers. * * 18-mar-86 -- jaw br/cvec changed to NOT use registers. * */#include "../data/if_css_data.c"int cssprobe(), cssattach(), cssrint(), cssxint();u_short cssstd[] = { 0 };struct uba_driver cssdriver = { cssprobe, 0, cssattach, 0, cssstd, "css", cssinfo };#define CSSUNIT(x) minor(x)int cssinit(), cssstart(), cssreset();/* * "Lower half" of IMP interface driver. * * Each IMP interface is handled by a common module which handles * the IMP-host protocol and a hardware driver which manages the * hardware specific details of talking with the IMP. * * The hardware portion of the IMP driver handles DMA and related * management of UNIBUS resources. The IMP protocol module interprets * contents of these messages and "controls" the actions of the * hardware module during IMP resets, but not, for instance, during * UNIBUS resets. * * The two modules are coupled at "attach time", and ever after, * through the imp interface structure. Higher level protocols, * e.g. IP, interact with the IMP driver, rather than the CSS. *//* * Reset the IMP and cause a transmitter interrupt by * performing a null DMA. */cssprobe(reg) caddr_t reg;{ register struct cssdevice *addr = (struct cssdevice *)reg;#ifdef lint cssrint(0); cssxint(0);#endif addr->css_icsr = CSS_CLR; addr->css_ocsr = CSS_CLR; DELAY(50000); addr->css_icsr = 0; addr->css_ocsr = 0; DELAY(50000); addr->css_oba = 0; addr->css_owc = -1; addr->css_ocsr = CSS_IE | CSS_GO; /* enable interrupts */ DELAY(50000); addr->css_ocsr = 0; return (1);}/* * Call the IMP module to allow it to set up its internal * state, then tie the two modules together by setting up * the back pointers to common data structures. */cssattach(ui) struct uba_device *ui;{ register struct css_softc *sc = &css_softc[ui->ui_unit]; register struct impcb *ip; struct ifimpcb { struct ifnet ifimp_if; struct impcb ifimp_impcb; } *ifimp; if ((ifimp = (struct ifimpcb *)impattach(ui, cssreset)) == 0) return; sc->css_if = &ifimp->ifimp_if; ip = &ifimp->ifimp_impcb; sc->css_ic = ip; ip->ic_init = cssinit; ip->ic_start = cssstart; sc->css_ifuba.ifu_flags = UBA_CANTWAIT | UBA_NEED16;#ifdef notdef sc->css_ifuba.ifu_flags =| UBA_NEEDBDP;#endif}/* * Reset interface after UNIBUS reset. * If interface is on specified uba, reset its state. */cssreset(unit, uban) int unit, uban;{ register struct uba_device *ui; struct css_softc *sc; if (unit >= nNCSS || (ui = cssinfo[unit]) == 0 || ui->ui_alive == 0 || ui->ui_ubanum != uban) return; printf(" css%d", unit); sc = &css_softc[unit]; sc->css_if->if_flags &= ~IFF_RUNNING; /* must go through IMP to allow it to set state */ (*sc->css_if->if_init)(unit);}/* * Initialize interface: clear recorded pending operations, * and retrieve, and reinitialize UNIBUS resources. */cssinit(unit) int unit;{ register struct css_softc *sc; register struct uba_device *ui; register struct cssdevice *addr; int x, info; if (unit >= nNCSS || (ui = cssinfo[unit]) == 0 || ui->ui_alive == 0) { printf("css%d: not alive\n", unit); return(0); } sc = &css_softc[unit]; /* * Header length is 0 to if_ubainit since we have to pass * the IMP leader up to the protocol interpretaion * routines. If we had the deader length as * sizeof(struct imp_leader), then the if_ routines * would assume we handle it on input and output. */ if (if_ubainit(&sc->css_ifuba, ui->ui_ubanum, 0,(int)btoc(IMPMTU)) == 0) { printf("css%d: can't initialize\n", unit); ui->ui_alive = 0; sc->css_if->if_flags &= ~(IFF_UP | IFF_RUNNING); return(0); } sc->css_if->if_flags |= IFF_RUNNING; addr = (struct cssdevice *)ui->ui_addr; /* reset the imp interface. */ x = spl5(); addr->css_icsr = CSS_CLR; addr->css_ocsr = CSS_CLR; DELAY(100); addr->css_icsr = 0; addr->css_ocsr = 0; addr->css_icsr = IN_HRDY; /* close the relay */ DELAY(5000); splx(x); /* * This may hang if the imp isn't really there. * Will test and verify safe operation. */ x = 500; while (x-- > 0) { if ((addr->css_icsr & (IN_HRDY|IN_IMPNR)) == IN_HRDY) break; addr->css_icsr = IN_HRDY; /* close the relay */ DELAY(5000); } if (x <= 0) { printf("css%d: imp doesn't respond, icsr=%b\n", unit, CSS_INBITS, addr->css_icsr); goto down; } /* * Put up a read. We can't restart any outstanding writes * until we're back in synch with the IMP (i.e. we've flushed * the NOOPs it throws at us). * Note: IMPMTU includes the leader. */ x = spl5(); info = sc->css_ifuba.ifu_r.ifrw_info; addr->css_iba = (u_short)info; addr->css_iwc = -(IMPMTU >> 1); addr->css_icsr = IN_HRDY | CSS_IE | IN_WEN | ((info & 0x30000) >> 12) | CSS_GO; splx(x); return(1);down: ui->ui_alive = 0; return(0);}/* * Start output on an interface. */cssstart(dev) dev_t dev;{ int unit = CSSUNIT(dev), info; struct uba_device *ui = cssinfo[unit]; register struct css_softc *sc = &css_softc[unit]; register struct cssdevice *addr; struct mbuf *m; u_short cmd; if (sc->css_ic->ic_oactive) goto restart; /* * Not already active, deqeue a request and * map it onto the UNIBUS. If no more * requeusts, just return. */ IF_DEQUEUE(&sc->css_if->if_snd, m); if (m == 0) { sc->css_ic->ic_oactive = 0; return; } sc->css_olen = if_wubaput(&sc->css_ifuba, m);restart: /* * Have request mapped to UNIBUS for transmission. * Purge any stale data from the BDP, and start the output. */ if (sc->css_ifuba.ifu_flags & UBA_NEEDBDP) UBAPURGE(sc->css_ifuba.ifu_uba, sc->css_ifuba.ifu_w.ifrw_bdp, sc->css_ifuba.ifu_uban); addr = (struct cssdevice *)ui->ui_addr; info = sc->css_ifuba.ifu_w.ifrw_info; addr->css_oba = (u_short)info; addr->css_owc = -((sc->css_olen + 1) >> 1); cmd = CSS_IE | OUT_ENLB | ((info & 0x30000) >> 12) | CSS_GO; addr->css_ocsr = cmd; sc->css_ic->ic_oactive = 1;}/* * Output interrupt handler. */cssxint(unit){ register struct uba_device *ui = cssinfo[unit]; register struct css_softc *sc = &css_softc[unit]; register struct cssdevice *addr; addr = (struct cssdevice *)ui->ui_addr; if (sc->css_ic->ic_oactive == 0) { printf("css%d: stray output interrupt csr=%b\n", unit, addr->css_ocsr, CSS_OUTBITS); return; } sc->css_if->if_opackets++; sc->css_ic->ic_oactive = 0; if (addr->css_ocsr & CSS_ERR){ sc->css_if->if_oerrors++; printf("css%d: output error, ocsr=%b icsr=%b\n", unit, addr->css_ocsr, CSS_OUTBITS, addr->css_icsr, CSS_INBITS); } if (sc->css_ifuba.ifu_xtofree) { m_freem(sc->css_ifuba.ifu_xtofree); sc->css_ifuba.ifu_xtofree = 0; } if (sc->css_if->if_snd.ifq_head) cssstart(unit);}/* * Input interrupt handler */cssrint(unit){ register struct css_softc *sc = &css_softc[unit]; register struct cssdevice *addr; struct mbuf *m; int len, info; sc->css_if->if_ipackets++; /* * Purge BDP; flush message if error indicated. */ addr = (struct cssdevice *)cssinfo[unit]->ui_addr; if (sc->css_ifuba.ifu_flags & UBA_NEEDBDP) UBAPURGE(sc->css_ifuba.ifu_uba, sc->css_ifuba.ifu_r.ifrw_bdp, sc->css_ifuba.ifu_uban); if (addr->css_icsr & CSS_ERR) { printf("css%d: recv error, csr=%b\n", unit, addr->css_icsr, CSS_INBITS); sc->css_if->if_ierrors++; sc->css_flush = 1; } if (sc->css_flush) { if (addr->css_icsr & IN_EOM) sc->css_flush = 0; goto setup; } len = IMPMTU + (addr->css_iwc << 1); if (len < 0 || len > IMPMTU) { printf("css%d: bad length=%d\n", len); sc->css_if->if_ierrors++; goto setup; } /* * The offset parameter is always 0 since using * trailers on the ARPAnet is insane. */ m = if_rubaget(&sc->css_ifuba, len, 0); if (m == 0) goto setup; if ((addr->css_icsr & IN_EOM) == 0) { if (sc->css_iq) m_cat(sc->css_iq, m); else sc->css_iq = m; goto setup; } if (sc->css_iq) { m_cat(sc->css_iq, m); m = sc->css_iq; sc->css_iq = 0; } impinput(unit, m, sc->css_if);setup: /* * Setup for next message. */ info = sc->css_ifuba.ifu_r.ifrw_info; addr->css_iba = (u_short)info; addr->css_iwc = - (IMPMTU >> 1); addr->css_icsr = IN_HRDY | CSS_IE | IN_WEN | ((info & 0x30000) >> 12) | CSS_GO;}#endif
⌨️ 快捷键说明
复制代码
Ctrl + C
搜索代码
Ctrl + F
全屏模式
F11
切换主题
Ctrl + Shift + D
显示快捷键
?
增大字号
Ctrl + =
减小字号
Ctrl + -