📄 gmakefile.win
字号:
#!gmake# -*- Mode: Makefile -*-# # The contents of this file are subject to the Mozilla Public# License Version 1.1 (the "License"); you may not use this file# except in compliance with the License. You may obtain a copy of# the License at http://www.mozilla.org/MPL/# # Software distributed under the License is distributed on an "AS# IS" basis, WITHOUT WARRANTY OF ANY KIND, either express or# implied. See the License for the specific language governing# rights and limitations under the License.# # The Original Code is the Netscape Portable Runtime (NSPR).# # The Initial Developer of the Original Code is Netscape# Communications Corporation. Portions created by Netscape are # Copyright (C) 2001 Netscape Communications Corporation. All# Rights Reserved.# # Contributor(s):# # Alternatively, the contents of this file may be used under the# terms of the GNU General Public License Version 2 or later (the# "GPL"), in which case the provisions of the GPL are applicable # instead of those above. If you wish to allow use of your # version of this file only under the terms of the GPL and not to# allow others to use your version of this file under the MPL,# indicate your decision by deleting the provisions above and# replace them with the notice and other provisions required by# the GPL. If you do not delete the provisions above, a recipient# may use your version of this file under either the MPL or the# GPL.# ifndef MOZ_SRC_FLIPPED$(error MOZ_SRC_FLIPPED is not set)endififndef MOZ_TOPMOZ_TOP=mozillaendifMOZ_DIST_FLIPPED = $(MOZ_SRC_FLIPPED)/mozilla/distifdef MOZ_DEBUGMOZ_OBJDIR = WIN32_D.OBJelseMOZ_OBJDIR = WIN32_O.OBJendifNSPR_CONFIGURE := ../configure \ --with-mozilla \ --with-dist-prefix=$(MOZ_DIST_FLIPPED) \ --with-dist-bindir=$(MOZ_DIST_FLIPPED)/$(MOZ_OBJDIR)/bin \ --with-dist-libdir=$(MOZ_DIST_FLIPPED)/$(MOZ_OBJDIR)/libifeq (,$(MOZ_DEBUG)$(MOZ_TRACE_MALLOC))NSPR_CONFIGURE := $(NSPR_CONFIGURE) --enable-optimize --disable-debugendifdefine MAKE_OBJDIRif test ! -d $(@D) ; then rm -rf $(@D) ; nsinstall -D $(@D) ; fiendefall:: build_all# Argh. nmake keeps the cwd from cmd to cmd and gmake does not# Furthermore, shmsdos doesn't support '&&' so there's a chance the# 'cd' could fail and configure would be run in the wrong dir#$(MOZ_OBJDIR)/config.status: configure configure.in @$(MAKE_OBJDIR) cd $(MOZ_OBJDIR)/ ; \ sh $(NSPR_CONFIGURE)build_all: $(MOZ_OBJDIR)/config.status check_old gmake -C $(MOZ_OBJDIR)clobber_all: $(MOZ_OBJDIR)/config.status check_old gmake -C $(MOZ_OBJDIR) clobber_alldistclean: check_old rm -rf WIN32_D.OBJ WIN32_O.OBJcheck_old: @if test -f Makefile; then gmake distclean; fi
⌨️ 快捷键说明
复制代码
Ctrl + C
搜索代码
Ctrl + F
全屏模式
F11
切换主题
Ctrl + Shift + D
显示快捷键
?
增大字号
Ctrl + =
减小字号
Ctrl + -