本资源包含 11 个源码文件 支持在线预览，点击文件名即可查看
温馨提示：点击文件名或"查看源码"按钮可在线浏览源代码，支持语法高亮显示。
资源详细信息
his project was built and tested with WinAVR-20060125. Make sure the MCU target define in the Mak - 资源详细说明
his project was built and tested with WinAVR-20060125.
Make sure the MCU target define in the Makefiles corresponds to the AVR you are using!!
To build the code, just install WinAVR and run "make" from the console in echomaster and
echoslave subdirs.
"make program" will program the device if you have a AVRISP attached.
Remember to set the AVR device to at least 8MHz. The AVR may use the programmable clock
from MC1319x, just remember to check if the MC1319x and SPI communication is working FIRST!
Otherwise you wont get any clock signal to the AVR and then you can t program it or reset
the fuses!
The MC1319x has default clock output of 32kHz so you will have to set your programmer to
a very low frequency (<=32kHz/4) to be able to program it while it is running on that!
his project was built and tested with WinAVR-20060125. Make sure the MCU target define in the Mak - 源码文件列表
立即下载 his project was built and test
提示：下载后请用压缩软件解压，推荐使用 WinRAR 或 7-Zip
下载说明与使用指南
下载说明
- 本资源需消耗 2积分
- 24小时内重复下载不扣分
- 支持断点续传功能
- 资源永久有效可用
使用说明
- 下载后使用解压软件解压
- 推荐使用 WinRAR 或 7-Zip
- 如有密码请查看资源说明
- 解压后即可正常使用
积分获取方式
- 上传优质资源获得积分
- 每日签到免费领取积分
- 邀请好友注册获得奖励
- 查看详情 →