虫虫首页|资源下载|资源专辑|精品软件
登录|注册

realizes

  • java实现一个网络聊天室-java realizes a network chatroom ,Java,Applet/Applet 本软件是会员软件,如果你是会员

    java实现一个网络聊天室-java realizes a network chatroom ,Java,Applet/Applet 本软件是会员软件,如果你是会员,请登陆。如果不是会员请注册。

    标签: Applet java chatroom realizes

    上传时间: 2013-12-09

    上传用户:牛布牛

  • 基于MSP430单片机的智能水位计设计

      为解决我国水位监测野外条件下长期无人看守的问题,研制开发了基于MSP430单片机的智能水位计。从其组成到各功能分别进行了详细的介绍,该智能水位计不仅实现了水位数据的实时监测、记录和定期采集等多种工作模式,而且提高了水位监测精度,实现了水位监测的智能化。   Abstract:   In order to solve the problems of long-term unmanned observation in the field water monitoring,an intelligence water-level meter based on MSP430 is developed composition and every function moduce of the water level meter was introduced in detail. It not only realizes water level data collection and storage, regularly gathering and so on, but also improves the water-level precision , finally realizes the intelligence.  

    标签: MSP 430 单片机 水位计

    上传时间: 2013-11-17

    上传用户:417313137

  • 基于MSP430F1611单片机的音频信号分析仪设计

      为了使音频信号分析仪小巧可靠,成本低廉,设计了以2片MSP430F1611单片机为核心的系统。该系统将音频信号送入八阶巴特沃兹低通滤波器,对信号进行限幅放大、衰减、电平位移、缓冲,并利用一单片机负责对前级处理后的模拟信号进行采样,将采集得到的音频信号进行4 096点基2的FFT计算,并对信号加窗函数提高分辨率,另一单片机负责对信号的分析及控制显示设备。此设计精确的测量了音频信号的功率谱、周期性、失真度指标,达到较高的频率分辨率,并能将测量结果通过红外遥控器显示在液晶屏上。   Abstract:   o make the audio signal analyzer cheaper, smaller and more reliable, this system sends the audio signal to the eight-order butterworth filter, and then amplifies, attenuates, buffers it in a limiting range, transfers the voltage level of the signal before utilizing two MSP430F1611 MCU to realize the audio analysis. One is charged for sampling and dealing with the processed audio signal collected by the 4096 point radix-2 FFT calculation and imposes the window function to improve the frequency resolution. The other one controls the display and realizes the spectrum, periodicity, power distortion analysis in high resolution which is displayed in the LCD screen through the infrared remote control.

    标签: F1611 1611 430F MSP

    上传时间: 2013-12-11

    上传用户:jasonheung

  • 基于凌阳单片机的步进电机加减速的控制方法

    提出一种基于凌阳单片机的步进电机加减速的控制方法。采用凌阳科技推出的16位结构工控单片机SPMC75F2413A为控制器,由Allegro公司生产的两相步进电机专用驱动器件SLA7042M构成步进电机的驱动电路,在传统的3段直线加减速控制算法基础上增加至7段S形曲线加减速过程,控制步进电机的启动和停止。实验结果表明,该控制方法克服了直线加减速中不连续、易造成系统冲击的问题,整个系统实现柔性控制,电机启动、停止连续性能提高30%。 Abstract:  The method of controlled stepping motor is referred based on SPMC75F2413A MCU, which adopts the 16 knots SPMC75F2413A MCU as the controller. The special-purpose actuation chip SLA7042M of two stepping motor produced by Allegro Corporation constituted to actuation electric circuit. The purpose of increasing to seven section of S shape curve based on the traditional three sections of straight line is to control the start and stop process of stepping motor. The experimental results show that the control method solves easy to pull-out and overshot problems. The overall system realizes flexible control, and the performance of motor start or stop continuity is increased 30%

    标签: 凌阳单片机 步进电机 控制方法

    上传时间: 2013-12-08

    上传用户:jiangfire

  • 基于C8051F020单片机的多路压力测量仪

    介绍了一种基于C8051F020单片机的多路压力测量仪。该测量仪选用电阻应变式压力传感器采集压力信号,并经放大电路处理后送入C8051F020单片机,再由C8051F020单片机内部的A/D转换器将采集到的压力信号进行模数转化,然后分别对数据进行存储和显示。该测量仪能测量6路压力信号,并且各测量点都能单独检测和设置。由于采用了C8051F020单片机,简化了硬件电路,增强了抗干扰能力,使得测量仪具有测量精度高,冲击小等特点。 Abstract:  A measurement apparatus for multi-channel pressure based on single chip microcomputer is introduced.It can measure 6 channels signal of the pressure,and the pressure measure points can be detection and located individually.The pressure signal sampling is obtained by resistor stress-type pressure sensors,the digital signals of 6 channels are collected through amplifying and adjustment circuit of pressure signals and internal integrated A/D converter of MCU.Finally,and it realizes the function to store and display data separately.C8051F020 was used to made hardware circuit simple,and it also enhanced the anti-interference ability.It features high precision and little impact.

    标签: C8051F020 单片机 多路 压力

    上传时间: 2013-11-15

    上传用户:yare

  • CAN与RS232转换节点的设计与实现

    CAN与RS232转换节点的设计与实现 介绍将CAN总线接口与RS232总线接口相互转换的设计方法和2种总线电平转换关系,实现CAN总线与各模块的接口设计,制定了相应的软硬件设计方案,并给出软件设计流程图以及部分硬件设计原理图。为CAN总线与RS232总线互联提供了一种方法,对CAN总线与RS232总线接口设备的互联和广泛应用的实现具有重要意义。关键词:CAN总线;RS-232总线;串行通信Design and Realization of CAN and RS232 Transformation NodeZHOU Wei, CHENG Xiao-hong(Information Institute, Wuhan University of Technology, Wuhan 430070)【Abstract】This paper introduces one design method of the CAN bus interface and the RS232 bus interface interconversion, emphasizes two kindof bus level transformation relations, realizes the CAN bus and various modules connection design, formulates the design proposal of correspondingsoftware and hardware, and gives the flow chart of software design as well as the partial schematic diagram of hardware design. It providesonemethod for the CAN bus and the RS232 bus interconnection, has the vital significance to widespread application realization of the CAN busand theRS232 bus interface equipment interconnection.【Key words】CAN bus; RS-232 bus; serial communication

    标签: CAN 232 RS 转换

    上传时间: 2013-11-04

    上传用户:leesuper

  • 场效应管产品指南

    The super-junction structure, which has P-type pillar layers as shown left, realizes high withstand voltage and ON-resistance lower than the conventional theoretical limit of silicon.

    标签: 场效应管 产品指南

    上传时间: 2014-12-30

    上传用户:qwer0574

  • This thesis has recommended mainly systematic design and simulation of the bank ATM (ATM ) realize t

    This thesis has recommended mainly systematic design and simulation of the bank ATM (ATM ) realize the course, and has introduced each function module of this system in detail , including deposit and withdraw, transfer accounts, inquire about, revise the concrete course that realize in password and concrete course that realizes of the module

    标签: recommended systematic simulation ATM

    上传时间: 2015-10-06

    上传用户:yzhl1988

  • In this paper, it is designed a platform for least deviation linear interpolation with two axis line

    In this paper, it is designed a platform for least deviation linear interpolation with two axis linear guides, and it realizes the linear interpolator by PIC microprocessor with MPLAB C language in PIC microprocessor.

    标签: interpolation deviation designed platform

    上传时间: 2017-07-24

    上传用户:维子哥哥

  • 基于2.4G的双电机遥控船模控制系统设计

    以STC12C5A60S2单片机为控制核心,采用2.4G(JF24D)无线遥控模块进行无线发射与接收,设计了一种双电机遥控船模控制系统.该系统通过切换档杆实现前进后退,方向盘左右转动、暂停按钮等控制直流电机的正转、反转、暂停,使得电机驱动的遥控船模实现前进后退、左右转向、暂停等功能,有效解决了驱动功率小和船模之间相互干扰等问题,可广泛应用于遥控船模领域.Using STC12C5A60S2 single-chip microcomputer as the controller and 2.4 G(JF24D)wireless remote control module for wireless transmission and reception, a dual-motor remote control ship model control system is designed. The system realizes forward and backward by switching the gear lever. The steering wheel rotates left and right and the pause button controls the forward, reverse and pause of the dc motor. The remote controller of ship model driven by the motor realizes forward and backward, left and right steering, pause and other functions. The ship model control system can effectively solve the problems of small driving power and mutual interference between ship models, and can be widely used in the field of remote controller of ship model.

    标签: 电机 遥控船模 控制系统

    上传时间: 2022-03-26

    上传用户:tigerwxf1