虫虫首页|资源下载|资源专辑|精品软件
登录|注册

inductive

  • An explanation of how to use the inductive method for debugging.

    An explanation of how to use the inductive method for debugging.

    标签: explanation debugging inductive method

    上传时间: 2013-12-16

    上传用户:hoperingcong

  • msp430

    msp430The LDC1312 and LDC1314 are 2- and 4-channel, 1• Easy-to-use – minimal configuration required 12-bit inductance to digital converters (LDCs) for • Measure up to 4 sensors with one IC inductive sensing solutions. With multiple channels • Multiple channels support environmental and and support for remote sensing, the LDC1312 and aging compensation LDC1314 enable the performance and reliability benefits of inductive sensing to be realized at minimal• Multi-channel remote sensing provides lowest cost and power. The products are easy to use, onlysystem cost requiring that the sensor frequency be within 1 kHz • Pin-compatible medium and high-resolution and 10 MHz to begin sensing. The wide 1 kHz to 10 options MHz sensor frequency range also enables use of very small PCB coils, further reducing sensing– LDC1312/4: 2/4-ch 12-bit LDC solution cost and size.– LDC1612/4: 2/4-ch 28

    标签: msp 430

    上传时间: 2016-07-22

    上传用户:tongmoonsky

  • L9352B

    Description The L9352B is an integrated quad low-side power switch to drive inductive loads like valves used in ABS systems. Two of the four channels are current regulators with current range from 0 mA to 2.25 A. All channels are protected against fail functions. They are monitored by a status output.

    标签: L9352B

    上传时间: 2019-03-27

    上传用户:guaixiaolong

  • Interference+Mitigation+Techniques

    This research work aims at eliminating the off-chip RF SAW filters from fre- quency division duplexed (FDD) receivers. In the first approach, a monolithic passive RF filter was constructed using on-chip capacitors and bondwire inductors. The bond- wire characteristics were studied in details and the effect of mutual inductive coupling between the bondwires on the filter performance was analyzed. Based on that, a bond- wire configuration was proposed to improve the frequency response of the filter. The filter was implemented in 0.18 µm CMOS process for WCDMA applications.

    标签: Interference Mitigation Techniques

    上传时间: 2020-05-27

    上传用户:shancjb

  • Reduce buck-converter EMI

    Reduce buck-converter EMI and voltage stress by minimizing inductive parasitics

    标签: EMI

    上传时间: 2022-07-18

    上传用户:默默