AT attachment with Packet Interface - 5 (ATA/ATAPI-5)
上传时间： 2019-11-19
上传用户：wang1113
STC单片机资料 请用逗号分隔标签 * 资料描述：
上传时间： 2019-12-02
上传用户：hjd0303
Wireless penetration has witnessed explosive growth over the last two decades. Accordingly, wireless devices have become much denser per unit area, resulting in an overcrowded usage of wireless resources. To avoid radio interferences and packet collisions, wireless stations have to exchange control messages to coordinate well. The existing wisdoms of conveying control messages could be classified into three categories: explicit, implicit, or hybrid.
标签： Transmission attachment Networks Wireless in
上传时间： 2020-05-26
上传用户：shancjb
A power semiconductor module is basically a power circuit of different materials assembled together using hybrid technology, such as semiconduc- tor chip attachment, wire bonding, encapsulation, etc. The materials involved cover a wide range from insulators, conductors, and semiconduc- tors to organics and inorganics. Since these materials all behave differently under various environmental, electrical, and thermal stresses, proper selec- tion of these materials and the assembly processes are critical. In-depth knowledge of the material properties and the processing techniques is there- fore required to build a high-performance and highly reliable power module.
标签： Manufacture Electronic Modules Design Power
上传时间： 2020-06-07
上传用户：shancjb
Agilent 34401A Service Guide.pdfIEC Measurement Category II includes electrical devices connected to mains at an outlet on a branch circuit. Such devices include most small appliances, test equipment, and other devices that plug into a branch outlet or socket. The 34401A may be used to make measurements with the HI and LO inputs connected to mains in such devices, or to the branch outlet itself (up to 300 VAC). However, the 34401A may not be used with its HI and LO inputs connected to mains in permanently installed electrical devices such as the main circuit-breaker panel, sub-panel disconnect boxes, or permanently wired motors. Such devices and circuits are subject to overvoltages that may exceed the protection limits of the 34401A. Note: Voltages above 300 VAC may be measured only in circuits that are isolated from mains. However, transient overvoltages are also present on circuits that are isolated from mains. The Agilent 34401A are designed to safely withstand occasional transient overvoltages up to 2500 Vpk. Do not use this equipment to measure circuits where transient overvoltages could exceed this level. Additional Notices Waste Electrical and Electronic Equipment (WEEE) Directive 2002/96/EC This product complies with the WEEE Directive (2002/96/EC) marking requirement. The affixed product label (see below) indicates that you must not discard this electrical/electronic product in domestic household waste. Product Category: With reference to the equipment types in the WEEE directive Annex 1, this product is classified as a "Monitoring and Control instrumentation" product. Do not dispose in domestic household waste. To return unwanted products, contact your local Agilent office, or see www.agilent.com/environment/product for more information. Agilent 34138A Test Lead Set The Agilent 34401A is compatible with the Agilent 34138A Test Lead Set described below. Test Lead Ratings Test Leads - 1000V, 15A Fine Tip Probe attachments - 300V, 3A Mini Grabber attachment - 300V, 3A SMT Grabber attachments - 300V, 3A Operation The Fine Tip, Mini Grabber, and SMT Grabber attachments plug onto the probe end of the Test Leads. Maintenance If any portion of the Test Lead Set is worn or damaged, do not use. Replace with a new Agilent 3413
标签： agilent
上传时间： 2022-02-20
上传用户：zinuoyu
