GSM Call Flow MS Terminated Call Procedure Mobile - Originating Call Procedure INTRA_VLR LOCATION UPDATING OR IMSI ATTACH( in old VLR )
标签： Procedure Call Originating Terminated
上传时间： 2017-07-27
上传用户：mpquest
The PCA9544A provides 4 interrupt inputs, one for each channeland one open drain interrupt output. When an interrupt is generated byany device, it will be detected by the PCA9544A and the interruptoutput will be driven LOW. The channel need not be active fordetection of the interrupt. A bit is also set in the control byte.Bits 4 – 7 of the control byte correspond to channels 0 – 3 of thePCA9544A, respectively. Therefore, if an interrupt is generated byany device connected to channel 2, the state of the interrupt inputs isloaded into the control register when a read is accomplished.Likewise, an interrupt on any device connected to channel 0 wouldcause bit 4 of the control register to be set on the read. The mastercan then address the PCA9544A and read the contents of thecontrol byte to determine which channel contains the devicegenerating the interrupt. The master can then reconfigure thePCA9544A to select this channel, and locate the device generatingthe interrupt and clear it. The interrupt clears when the deviceOriginating the interrupt clears.
标签： 4channel multiple 9544A 9544
上传时间： 2014-12-27
上传用户：潜水的三贡
Digital mobile wireless communication and the Internet have undergone a fantastic growth in the last few years and, despite Originating from two different worlds, they are converging. This convergence corresponds to the evolution of mobile systems towards the highest broadband data transmissions (GSM, EDGE/GPRS, UMTS then HSDPA), while the computing world gets equipped with wireless technologies such as Wi-Fi or Wi-Max.
标签： Reconfigurable Systems Mobile Radio
上传时间： 2020-05-31
上传用户：shancjb
Microengineering and Microelectromechanical systems (MEMS) have very few watertight definitions regarding their subjects and technologies. Microengineering can be described as the techniques, technologies, and practices involved in the realization of structures and devices with dimensions on the order of micrometers. MEMS often refer to mechanical devices with dimensions on the order of micrometers fabricated using techniques Originating in the integrated circuit (IC) industry, with emphasis on silicon-based structures and integrated microelectronic circuitry. However, the term is now used to refer to a much wider range of microengineered devices and technologies.
标签： Microengineering Interfacing MEMS and
上传时间： 2020-06-06
上传用户：shancjb
