虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

N<b>AT</b>ional

  • 基于单片机的数字化B超键盘设计

    针对目前使用的RS232接口数字化B超键盘存在PC主机启动时不能设置BIOS,提出一种PS2键盘的设计方法。基于W78E052D单片机,采用8通道串行A/D转换器设计了8个TGC电位器信息采集电路,电位器位置信息以键盘扫描码序列形式发送,正交编码器信号通过XC9536XL转换为单片机可接收的中断信号,软件接收到中断信息后等效处理成按键。结果表明,在满足开机可设置BIOS同时,又可实现超声特有功能,不需要专门设计驱动程序,接口简单,成本低。 Abstract:  Aiming at the problem of the digital ultrasonic diagnostic imaging system keyboard with RS232 interface currently used couldn?蒺t set the BIOS when the PC boot, this paper proposed a design method of PS2 keyboards. Based on W78E052D microcontroller,designed eight TGC potentiometers information acquisition circuit with 8-channel serial A/D converter, potentiometer position information sent out with keyboard scan code sequentially.The control circuit based on XC9536 CPLD is used for converting the mechanical actions of the encoders into the signals that can be identified by the MCU, software received interrupt information and equivalently treatmented as key. The results show that the BIOS can be set to meet the boot, ultrasound specific functionality can be achieved at the same time, it does not require specially designed driver,the interface is simple and low cost.    

    标签: 单片机 B超 数字化 键盘设计

    上传时间: 2013-10-10

    上传用户:asdfasdfd

  • 剖析Intel IA32 架构下C 语言及CPU 浮点数机制 Version 0.01 哈尔滨工业大学 谢煜波 (email: xieyubo@126.com 网址:http://purec.b

    剖析Intel IA32 架构下C 语言及CPU 浮点数机制 Version 0.01 哈尔滨工业大学 谢煜波 (email: xieyubo@126.com 网址:http://purec.binghua.com) (QQ:13916830 哈工大紫丁香BBSID:iamxiaohan) 前言 这两天翻看一本C 语言书的时候,发现上面有一段这样写到 例:将同一实型数分别赋值给单精度实型和双精度实型,然后打印输出。 #include <stdio.h> main() { float a double b a = 123456.789e4 b = 123456.789e4 printf(“%f\n%f\n”,a,b) } 运行结果如下:

    标签: Version xieyubo Intel email

    上传时间: 2013-12-25

    上传用户:徐孺

  • 基于事件驱动的串口通讯控件 消息帧数据格式: 1 0 A B X X 其中 10 为消息标识, AB表示文本长度,L=A*100+B XX为配位字符,任意 控制帧数据格式

    基于事件驱动的串口通讯控件 消息帧数据格式: 1 0 A B X X 其中 10 为消息标识, AB表示文本长度,L=A*100+B XX为配位字符,任意 控制帧数据格式 0 1 A B M N 其中 01为控制标识, AB为请求标识 MN为附加标识 11表示请求对方接收文件,M表示描述字串中文件名子串的长度 N表示描述字串中文件大小子串的长度 10通知对方放弃传输 00通知文件传输完毕 01请求对方发送数据, MN为10请求发送下一个 MN为00请求重发 数据帧数据格式 0 0 A B M N 其中 00 为数据标识, AB表示数据长度,L=A*100+B MN为校验,M*100+N=A+B

    标签: 100 数据格式 10

    上传时间: 2015-10-06

    上传用户:拔丝土豆

  • 设B是一个n×n棋盘

    设B是一个n×n棋盘,n=2k,(k=1,2,3,…)。用分治法设计一个算法,使得:用若干个L型条块可以覆盖住B的除一个特殊方格外的所有方格。其中,一个L型条块可以覆盖3个方格。且任意两个L型条块不能重叠覆盖棋盘

    标签:

    上传时间: 2013-12-16

    上传用户:脚趾头

  • ITU-T G.729语音压缩算法。 description: Fixed-point description of commendation G.729 with ANNEX B Coding

    ITU-T G.729语音压缩算法。 description: Fixed-point description of commendation G.729 with ANNEX B Coding of Speech at 8 kbit/s using Conjugate-Structure Algebraic-Code-Excited Linear-Prediction (CS-ACELP) with Voice Activity Decision(VAD), Discontinuous Transmission(DTX), and Comfort Noise Generation(CNG).

    标签: description commendation Fixed-point 729

    上传时间: 2014-11-23

    上传用户:thesk123

  • Floyd-Warshall算法描述 1)适用范围: a)APSP(All Pairs Shortest Paths) b)稠密图效果最佳 c)边权可正可负 2)算法描述: a)初始化:d

    Floyd-Warshall算法描述 1)适用范围: a)APSP(All Pairs Shortest Paths) b)稠密图效果最佳 c)边权可正可负 2)算法描述: a)初始化:dis[u,v]=w[u,v] b)For k:=1 to n For i:=1 to n For j:=1 to n If dis[i,j]>dis[i,k]+dis[k,j] Then Dis[I,j]:=dis[I,k]+dis[k,j] c)算法结束:dis即为所有点对的最短路径矩阵 3)算法小结:此算法简单有效,由于三重循环结构紧凑,对于稠密图,效率要高于执行|V|次Dijkstra算法。时间复杂度O(n^3)。 考虑下列变形:如(I,j)∈E则dis[I,j]初始为1,else初始为0,这样的Floyd算法最后的最短路径矩阵即成为一个判断I,j是否有通路的矩阵。更简单的,我们可以把dis设成boolean类型,则每次可以用“dis[I,j]:=dis[I,j]or(dis[I,k]and dis[k,j])”来代替算法描述中的蓝色部分,可以更直观地得到I,j的连通情况。

    标签: Floyd-Warshall Shortest Pairs Paths

    上传时间: 2013-12-01

    上传用户:dyctj

  • 编写一个用SOR法解方程组Ax=b的计算机程序

    编写一个用SOR法解方程组Ax=b的计算机程序,其中 要求程序中不存系数A,分别对不同的阶数(例如n=15,80)取w=1.7,1.8,1.9,进行迭代,记录近似解 达到 时所用迭代次数k,观察松弛因子对收敛速度的影响。

    标签: SOR Ax 编写 方程

    上传时间: 2013-12-25

    上传用户:wcl168881111111

  • A* sudo sudo/* B* adduser script adduser C* rmuser script rmuser E* tout tout/*

    A* sudo sudo/* B* adduser script adduser C* rmuser script rmuser E* tout tout/* F* dumdum dumdum G* lostfile lostfile H* Mkfl.localsys Makefile.localsys I* spacegripe spacegripe J* sendmail.cf sendmail.cf N* remote remote.c O* distributed conrol distrib/* P* hosts and name server makerevhosts Q* xargs xargs/*

    标签: adduser script rmuser sudo

    上传时间: 2016-03-29

    上传用户:gxrui1991

  • 5.22④ 假设系数矩阵A和B均以三元组表作为存储结构。 试写出满足以下条件的矩阵相加的算法:假设三元组表A 的空间足够大

    5.22④ 假设系数矩阵A和B均以三元组表作为存储结构。 试写出满足以下条件的矩阵相加的算法:假设三元组表A 的空间足够大,将矩阵B加到矩阵A上,不增加A、B之外 的附加空间,你的算法能否达到O(m+n)的时间复杂度?其 中m和n分别为A、B矩阵中非零元的数目。

    标签: 5.22 矩阵 三元 系数

    上传时间: 2013-12-13

    上传用户:coeus

  • 3.画椭圆ellipse 4.利用ellipse and rectangle 画图 5.一个最优美的图案 6.输入3个数a,b,c

    3.画椭圆ellipse 4.利用ellipse and rectangle 画图 5.一个最优美的图案 6.输入3个数a,b,c,按大小顺序输出 :输入数组,最大的与第一个元素交换,最小的与最后一个元素交换,输出数组。 7.有n个整数,使其前面各数顺序向后移m个位置,最后m个数变成最前面的m个数

    标签: ellipse rectangle and 椭圆

    上传时间: 2016-11-16

    上传用户:royzhangsz