Multioutput monolithic regulators are easy to use and fi tinto spaces where multichip solutions cannot. Nevertheless,the popularity of multioutput regulators is temperedby a lack of options for input voltages above 30V andsupport of high output currents. The LT3692A fi lls thisgap with a DUAL monolithic regulator that operates frominputs up to 36V. It also includes a number of channeloptimization features that allow the LT3692A’s per-channelperformance to rival that of multichip solutions.
上传时间： 2014-01-03
上传用户：Huge_Brother
The RT9005A/B is a DUAL-output Linear regulator for DDR-SDRAM VDDQ supply and termination voltage VTT supply.
上传时间： 2013-11-13
上传用户：lmq0059
本软件是关于MAX338, MAX339的英文数据手册：MAX338, MAX339 8通道/双4通道、低泄漏、CMOS模拟多路复用器 The MAX338/MAX339 are monolithic, CMOS analog multiplexers (muxes). The 8-channel MAX338 is designed to connect one of eight inputs to a common output by control of a 3-bit binary address. The DUAL, 4-channel MAX339 is designed to connect one of four inputs to a common output by control of a 2-bit binary address. Both devices can be used as either a mux or a demux. On-resistance is 400Ω max, and the devices conduct current equally well in both directions. These muxes feature extremely low off leakages (less than 20pA at +25°C), and extremely low on-channel leakages (less than 50pA at +25°C). The new design offers guaranteed low charge injection (1.5pC typ) and electrostatic discharge (ESD) protection greater than 2000V, per method 3015.7. These improved muxes are pin-compatible upgrades for the industry-standard DG508A and DG509A. For similar Maxim devices with lower leakage and charge injection but higher on-resistance, see the MAX328 and MAX329.
上传时间： 2013-11-12
上传用户：18711024007
使用Nios II紧耦合存储器教程 Chapter 1. Using Tightly Coupled Memory with the Nios II Processor Reasons for Using Tightly Coupled Memory . . . . . . . . . . . . . . . . . . . . . . . 1–1 Tradeoffs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1–1 Guidelines for Using Tightly Coupled Memory . . . .. . . . . . . . 1–2 Hardware Guidelines . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1–2 Software Guidelines . . . . . . . . . . . . . . . . . . . . . . . . . .. . . . . . . . 1–3 Locating Functions in Tightly Coupled Memory . . . . . . . . . . . . . 1–3 Tightly Coupled Memory Interface . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1–4 Restrictions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1–4 DUAL Port Memories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .. . . . . . . 1–5 Building a Nios II System with Tightly Coupled Memory . . . . . . . . . . . 1–5
上传时间： 2013-10-12
上传用户：黄婷婷思密达
This application note describes how the existing DUAL-port block memories in the Spartan™-IIand Virtex™ families can be used as Quad-Port memories. This essentially involves a dataaccess time (halved) versus functionality (doubled) trade-off. The overall bandwidth of the blockmemory in terms of bits per second will remain the same.
上传时间： 2014-01-23
上传用户：15527161163
The SDI standards are the predominant standards for uncompressed digital videointerfaces in the broadcast studio and video production center. The first SDI standard,SD-SDI, allowed standard-definition digital video to be transported over the coaxial cableinfrastructure initially installed in studios to carry analog video. Next, HD-SDI wasto support high-definition video. Finally, DUAL link HD-SDI and 3G-SDIdoubled the bandwidth of HD-SDI to support 1080p (50 Hz and 60 Hz) and other videoformats requiring more bandwidth than HD-SDI provides.
上传时间： 2013-12-08
上传用户：liansi
WP369可扩展式处理平台-各种嵌入式系统的理想解决方案 ：Delivering unrivaled levels of system performance,flexibility, scalability, and integration to developers,Xilinx's architecture for a new Extensible Processing Platform is optimized for system power, cost, and size. Based on ARM's DUAL-core Cortex™-A9 MPCore processors and Xilinx’s 28 nm programmable logic,the Extensible Processing Platform takes a processor-centric approach by defining a comprehensive processor system implemented with standard design methods. This approach provides Software Developers a familiar programming environment within an optimized, full featured,powerful, yet low-cost, low-power processing platform.
上传时间： 2013-10-18
上传用户：cursor
半導體的產品很多，應用的場合非常廣泛，圖一是常見的幾種半導體元件外型。半導體元件一般是以接腳形式或外型來劃分類別，圖一中不同類別的英文縮寫名稱原文為 PDID：Plastic DUAL Inline Package SOP：Small Outline Package SOJ：Small Outline J-Lead Package PLCC：Plastic Leaded Chip Carrier QFP：Quad Flat Package PGA：Pin Grid Array BGA：Ball Grid Array 雖然半導體元件的外型種類很多，在電路板上常用的組裝方式有二種，一種是插入電路板的銲孔或腳座，如PDIP、PGA，另一種是貼附在電路板表面的銲墊上，如SOP、SOJ、PLCC、QFP、BGA。 從半導體元件的外觀，只看到從包覆的膠體或陶瓷中伸出的接腳，而半導體元件真正的的核心，是包覆在膠體或陶瓷內一片非常小的晶片，透過伸出的接腳與外部做資訊傳輸。圖二是一片EPROM元件，從上方的玻璃窗可看到內部的晶片，圖三是以顯微鏡將內部的晶片放大，可以看到晶片以多條銲線連接四周的接腳，這些接腳向外延伸並穿出膠體，成為晶片與外界通訊的道路。請注意圖三中有一條銲線從中斷裂，那是使用不當引發過電流而燒毀，致使晶片失去功能，這也是一般晶片遭到損毀而失效的原因之一。 圖四是常見的LED，也就是發光二極體，其內部也是一顆晶片，圖五是以顯微鏡正視LED的頂端，可從透明的膠體中隱約的看到一片方型的晶片及一條金色的銲線，若以LED二支接腳的極性來做分別，晶片是貼附在負極的腳上，經由銲線連接正極的腳。當LED通過正向電流時，晶片會發光而使LED發亮，如圖六所示。 半導體元件的製作分成兩段的製造程序，前一段是先製造元件的核心─晶片，稱為晶圓製造；後一段是將晶中片加以封裝成最後產品，稱為IC封裝製程，又可細分成晶圓切割、黏晶、銲線、封膠、印字、剪切成型等加工步驟，在本章節中將簡介這兩段的製造程序。
上传时间： 2013-11-04
上传用户：372825274
Features • Compatible with MCS-51® Products • 8K Bytes of In-System Programmable (ISP) Flash Memory – Endurance: 1000 Write/Erase Cycles • 4.0V to 5.5V Operating Range • Fully Static Operation: 0 Hz to 33 MHz • Three-level Program Memory Lock • 256 x 8-bit Internal RAM • 32 Programmable I/O Lines • Three 16-bit Timer/Counters • Eight Interrupt Sources • Full Duplex UART Serial Channel • Low-power Idle and Power-down Modes • Interrupt Recovery from Power-down Mode • Watchdog Timer • DUAL Data Pointer • Power-off Flag
标签： 8226 Programmable Compatible In-System
上传时间： 2015-06-27
上传用户：dianxin61
这是一篇介绍二分树复数小波的文章，里面很详细的介绍了DUAL tree complex wavelet transform。希望大家有帮助
上传时间： 2014-01-19
上传用户：ghostparker
