虫虫首页| 资源下载| 资源专辑| 精品软件
登录| 注册

Capacity_and_<b>CHANNEL</b>

  • 工业仪表显示,收音机LCD驱动,音箱/音响LCD段码屏驱动:VK2C21A/B/C/D(裸片可订货)

    产品型号:VK2C21A/B/C/D 产品品牌:VINKA/永嘉微/永嘉微电 封装形式:SOP28/24/20/16 裸片:DICE(邦定COB)/COG(邦定玻璃用) 产品年份:新年份 联 系 人:许硕  Q Q:191 888 5898 联系手机:18898582398(信) 原厂直销,工程服务,技术支持,价格最具优势!QT459 VK2C21A/B/C/D概述: VK2C21是一个点阵式存储映射的LCD驱动器,可支持最大80点(20SEGx4COM)或者最大128点(16SEGx8COM)的LCD屏。单片机可通过I2C接口配置显示参数和读写显示数据,也可通过指令进入省电模式。其高抗干扰,低功耗的特性适用于水电气表以及工控仪表类产品。 特点: ★  工作电压 2.4-5.5V ★  内置32 kHz RC振荡器 ★  偏置电压(BIAS)可配置为1/3、1/4 ★  COM周期(DUTY)可配置为1/4、1/8 ★  内置显示RAM为20x4位、16x8位 ★  帧频可配置为80Hz、160Hz ★  省电模式(通过关显示和关振荡器进入)

    标签: VK2C21 VK2C21A VK2C21B VK2C21C VK2C21D LCD抗干扰段码屏驱动 段码屏驱动抗干扰

    上传时间: 2022-06-09

    上传用户:2937735731

  • NTC计算公式 温度公式B值计算法

    描述了NTC使用B值计算出实际温度与输出的电压之间的关系。

    标签: ntc计算

    上传时间: 2022-06-15

    上传用户:

  • Quectel Wireless Solutions BC20-TE-B 原理图 V1.2

    BC20-TE-B NB-Iot 评估板评估板原厂原理图V1.2。完整对应实物装置。

    标签: BC20 NB-Iot Quectel

    上传时间: 2022-06-17

    上传用户:

  • ASR M08-B资料

    ASR M08-B设置软件 V3.2  arduino 2560+ASRM08-B测试程序  arduino UNO+ASRM08-B测试程序语音控制台灯电路图及C51源码(不带校验码) 继电器模块设置。   ASR M08-B是一款语音识别模块。首先对模块添加一些关键字,对着该模块说出关键字,串口会返回三位的数,如果是返回特定的三位数字,还会引起ASR M08-B的相关引脚电平的变化。【测试】①打开“ASR M08-B设置软件 V3.2.exe”。②选择“串口号”、“打开串口”、点选“十六进制显示”。③将USB转串口模块连接到语音识别模块上。接线方法如下:语音模块TXD --> USB模块RXD语音模块RXD --> USB模块TXD语音模块GND --> USB模块GND语音模块3V3 --> USB模块3V3(此端为3.3V电源供电端。)④将模块的开关拨到“A”端,最好再按一次上面的大按钮(按一次即可,为了确保模块工作在正确的模式)。⑤对着模块说“开灯”、“关灯”模块会返回“0B”、“0A”,表示正常(注意:0B对应返回值010,0B对应返回值010,返回是16进制显示的嘛,设置的时候是10进制设置的)。

    标签: ASR M08-B

    上传时间: 2022-07-06

    上传用户:aben

  • Program to simulate Rayleigh fading using a p-th order autoregressive model AR(p) according to % B

    Program to simulate Rayleigh fading using a p-th order autoregressive model AR(p) according to % Baddour s work: "Autoregressive modeling for fading channel simulation"

    标签: autoregressive according simulate Rayleigh

    上传时间: 2013-12-02

    上传用户:tb_6877751

  • 16 relay output channels and 16 isolated digital input channels LED indicators to show activated

    16 relay output channels and 16 isolated digital input channels LED indicators to show activated relays Jumper selectable Form A/Form B-type relay output channel Output status read-back Keep relay output values when hot system reset High-voltage isolation on input channels(2,500 VDC) Hi ESD protection(2,00VDC) High over-voltage protection(70VDC) Wide input range(10~50VDC) Interrupt handling capability High-density DB-62 connector Board ID

    标签: channels indicators activated isolated

    上传时间: 2016-02-15

    上传用户:dongbaobao

  • Wi-Fi pollution, or an excessive number of access points in the area, especially on the same or neig

    Wi-Fi pollution, or an excessive number of access points in the area, especially on the same or neighboring channel, can prevent access and interfere with the use of other access points by others, caused by overlapping channels in the 802.11g/b spectrum

    标签: especially pollution excessive the

    上传时间: 2017-07-29

    上传用户:我们的船长

  • Space-Time+Processing+for+Wireless+Communications

    In this thesis several asp ects of space-time pro cessing and equalization for wire- less communications are treated. We discuss several di?erent metho ds of improv- ing estimates of space-time channels, such as temp oral parametrization, spatial parametrization, reduced rank channel estimation, b o otstrap channel estimation, and joint estimation of an FIR channel and an AR noise mo del. In wireless commu- nication the signal is often sub ject to intersymb ol interference as well as interfer- ence from other users. 

    标签: Communications Space-Time Processing Wireless for

    上传时间: 2020-06-01

    上传用户:shancjb

  • AC220V转DC(12V15W )电源板AD设计硬件原理图+PCB文件 2层板设计 大小为100

    AC220V转DC(12V15W )电源板AD设计硬件原理图+PCB文件,2层板设计,大小为100*55mm,   ALTIUM设计的原理图+PCB文件,可以做为你的学习设计参考。主要器件型号如下:Library Component Count : 24Name                Description----------------------------------------------------------------------------------------------------2N3904              NPN General Purpose Amplifier2N3906              PNP General Purpose AmplifierBRIDGE1             Diode BridgeCON2                ConnectorCap                 CapacitorCap Pol1            Polarized Capacitor (Radial)D Zener             Zener DiodeDIODE               Diode 1N914         High Conductance Fast DiodeECELECTRO2            Electrolytic CapacitorFP103               FUSE-HHeader 2            Header, 2-PinINDUCTOR2           NMOS-2              N-Channel Power MOSFETPC837               OptoisolatorRES2-B              Res Varistor        Varistor (Voltage-Sensitive Resistor)T                   TR-2B               TRANS1UCC28051            Volt Reg            Voltage Regulator

    标签: 电源 pcb

    上传时间: 2021-11-21

    上传用户:kent

  • 音响功放测试方法

    說明:1,测试交流电源(Test AC Power Supply):A.中国(China):AC 220V+/-2%50Hz+/-2%B.美国(United States of America):AC 120V+/-2%60Hz+/-2%。C.英国(Britain):AC 240V+/-2%50Hz+/-2%D.欧洲(Europe):AC 230V+/-2%50Hz+/-2%E.日本(Japan):AC 100V+/-2%60Hz+/-2%F.墨西哥(Mexico):AC 127V+/-2%60Hz+/-2%2,测试温度条件(Test Temperature Conditions):25℃+/-2℃。3,测试以右声道为准(Standard Test Use Right Channell)4,信号由AUX插座输入(Signal From AUX Jack Input)。5,测试以音量最大,音调和平衡在中央位置(电子音调在正常状态)。(Test Volume Setup Max,Equalizer And Balance Setup Center)。6,标准輸出(Standard Output):A.输入1 KHz频率信号(Input 1 KHz Frequency Signal)B.左右声道输入信号测试右声道(L&R Input Signal Test Use R Channel)C.额定输出功率満(Rating Output Power Full)10 W,标准输出定为1w.(Rating Output Power Full 10 w,Standard Output Setup 1 W)D.额定输出功率1W到10w,标准输出定为500 mW(Rating Output Power 1 W To 10 W,Standard Output Setup 500 mW)E.额定输出功率小于1w,标准输出定为50 mW(Rating Output Power Not Full 1 W,Standard Output Setup 50 mW)F.标准輸出电压以V-VPR为准(Standard Output Voltage Use V-V/PR)。G.V-V/PR中P为额定输出功率,R为喇叭标称阻抗。

    标签: 音响功放

    上传时间: 2022-06-18

    上传用户: